LED Obstruction & Visual Signal Lighting
LED - Double - 12/24/48VDC
Installation & Maintenance Information
IF 1525
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Catalog Number
OWLFDR/12
OWLFDR/24
OWLFDR/48
Type
FAA L810
FAA L810
FAA L810
Application
Non-Hazardous Location
Non-Hazardous Location
Non-Hazardous Location
Description
RED, DOUBLE, 12VDC
RED, DOUBLE, 24VDC
RED, DOUBLE, 48VDC
WARNING
ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION.
TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE,
DISCONNECT POWER BEFORE ATTEMPTING INSTALLATION OF
THE LIGHT FIXTURE.
Failure to install the unit in accordance with the National Electrical Code
(NEC), all applicable Federal, State and local codes as well as
Underwriter’s Laboratories (UL) safety standards for the installation,
location and application may cause serious personal injury, death,
property damage and/or product malfunction.
These Instructions are guidelines for the installation of Light Emitting
Diode (LED) fixtures. Installation may vary depending on the application.
Licensed electricians should provide all installation services requiring
connection to a power source.
CAUTION
To retain seal integrity (and preserve warranty) do not loosen or remove
the clamp holding the light assembly together.
NOTE
• Removal or loosening of the clamp will void all warranties
• Obstruction Lights - Do not mount this light assembly upside-down
• Visual Signals - Any mounting orientation is allowable
• The light will not meet necessary FAA specifications if mounted
incorrectly
INSTALLATION
1.
•
•
•
2.
The dual wire housing [2] has a 1” NPT (3/4" bushing) end to be
assembled to conduit
Use a 1-1/2” wrench to tighten and attach the dual wire housing [2] to
the conduit
Tighten the 1/4 screw to secure the dual wire housing in position
Remove reducing bushing [5] if threading into 1” NPT conduit
Feed the supply wires through the conduit and dual wire housing [2]
leaving approx 6” of wire for termination inside the wire housing [2]
3.
•
•
•
Electrically connect the supply wires to the light assembly [1] wires
Connect the light assembly wire (with voltage label) to the positive [+]
line
Connect the light assembly wire [without label] to the negative [-] line
Connect the grounding wire [from green screw] to the Ground line
4.
Tuck the connected wires inside the dual wire housing [2]
5.
Position each light assembly [1] on the dual wire housing [2] and use the
holding screws [3] to secure the light assembly in place
6.
Restore power and verify operation
All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable. The accuracy or
completeness thereof are not guaranteed. In accordance with Crouse-Hinds "Terms and Conditions of Sale", and since conditions of use are outside our control,
the purchaser should determine the suitability of the product for his intended use and assumes all risk and liability whatsoever in connection therewith.
Cooper Industries Inc.
Crouse-Hinds Division
PO Box 4999, Syracuse, New York 13221 • U.S.A.
Copyright© 2007, Cooper Industries, Inc.
IF 1525
Revision 1
New 04/07