For Con-Tech Lighting 3-Wire Surface Mounted Junction Box: SMJ3
Quick Connect
Strain Relief
Black to Black
White to White
Green to Ground
Quick Connect
• Failure to comply with these instructions could result in potentially fatal electric shock and/or property damage. Hard-wired components are
for use with a grounded, 3-wire source of supply. Use in dry locations only.
• Direct wire, 5A continuous run load (max). Installation by licensed electrician only
• Disconnect power before installing or servicing.
• To reduce the possibility of injury, mount the fixture on a surface that is structurally sound.
INSTALLATION PROCEDURES
• Remove cover from housing by removing (2) screws on the front of the assembly.
• Remove nut from flexible conduit connector (included)and feed through opening on housing.
• Place green ground wire connector over conduit connector and tighten hex nut until conduit connector is secure.
• Feed supply wires through opening and secure conduit to conduit connector with (2) screws.
• Secure housing to mounting surface with (2) mounting screws (included).
• Connect black wire to black switch wire, white wire to white wire and green to ground. Use proper splicing hardware (3) wire nuts provided.
• Carefully tuck connected wired in housing, replace cover and screw into place.
• Use 3PP2, 3PP3 plug and play connectors from SMJ3 to fixtures.
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for later use.
• Turn off power at fuse or circuit breaker box before installation or before doing any maintenance work.
• Product must be grounded to avoid potential electric shock and any other potential hazards.
• Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in compliance with National
Electrical Code and local codes. Use of accessory equipment is not recommended.
• Installing contrary to instructions may cause unsafe conditions.
• Do not block light from the trim aperture, in whole or in part, as this may cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have supply wire rated at 60°C. Consult a qualified electrician before installation.
• To avoid hazards to children, account for all parts and properly dispose of all packing materials.
• Call the Technical Support department at Con-Tech Lighting with any installation questions: 847.559.5500.
All specifications subject to change without notice.
1-847-559-5500
www.con-techlighting.com
This document can be recycled.
SMJ3 INST