FSH 7709.56 - ROAD PRECONSTRUCTION HANDBOOK 10/85 R1 SUPPLEMENT 1 4.84 - Inslope, Outslope, and Crown. Outsloping should be limited to areas with erosion resistant soils and to those areas where road grade is less than 8 percent. Incorporate grade reversals or dips in the design to ensure positive drainage of outslope roads. Roads should not be outlsloped where winter haul is anticipated. Generally, positive drainage is not achieved by outsloping unless the percent of outsloping exceeds the road grade by 1 percent. Outslopping is more effective on flatter grades in the range of 0 to 4 percent. Water coming over the cutbank will tend to cut its own ditch on steeper outsloped roads because the water will have a greater tendency to run along the inside edge of the road than to flow across the road. Remove this supplement in its entirety. 4.84-Inslope, Outslope, and Crown is now addressed in FSH 7709.56_40, section 44.1-Traveled Way Surface Shapes. Addresses erosive soils, season of use, refers designer to “Traveled Way Surface Shape,” Publication 9777 1808-SDTDC, for additional guidance including how to choose appropriate surface shape, considerations including soils and grades, effective use of of surface shapes, etc.