Quiz # 10
Mode 6
Name ________________________
1. What is the maximum number of “modes” that may be displayed on todays generic scanners
A. Seven
B. Eleven
C. Four
D. Nine
2. Some scanners will display scientific _______________read outs of mode 6 data?
A. Real
B. Hexidecimal
C. Partial
D. Complete
3. Mode 6 _________________ monitors test for various emissions control systems.?
A. Freeze Frame data
B. DTC
C. Non-continuous
D. OEM
4. If the status of a certin monitor reads “not complete” what should the technician do when
monitoring the Mode 6 data for that component?
A. Disregard the readings for that component.
B. No Mode 6 data will be listed for that component.
C. Use the data as it is a record of the last time the monitor ran.
D. Use only the hexidecimal values of the monitor reading.
5. The acronym TLT means?
A. Test Limit Type.
B. Test Length Time’
C. Testing Logistics Total.
D. Test Lean Total.
6. In order to change raw data into an understandable final value, what must a technician do?
A. Raw data is the final value needed.
B. Raw data must be converted into a hexidecimal value
C. Raw data must be converted into a decimal value.
D. Raw data must be subjected to manufacturer’s conversion factor.
7. What does the scan tool Mode 6 test data indicate in the table below?
TID:
O2 monitor
CID:
Min/max
Value
1.25
Min:
0.45
Max:
3.5
Unit
A
A. A failed test.
B. No test was run.
C. Data is inconclusive
D. A passed test.
8. What does the scan tool Mode 6 test data indicate in the table below?
TID:
Cat. monitor
CID:
Min/max
Value
.45
Min:
0.35
A. Catalytic Converter is weak.
B. No test was.
C. Data is inconclusive
D. Catalytic Converter is in good working condition.
Max:
1.00
Unit
A