WIRING INSTRUCTIONS
For Transformers: LVT-500-C, LVT-600-C and LVT-1200-C-24
INSTALLATION PROCEDURES
• Use #10 wire for 25A circuits; cap off the unused end.
• Under 15 feet, use standard tap; 15 to 40 feet use boost tap.
• Ensure that all wiring connections are tight. For field connections, use
wires suitable for at least 90°C (194°F).
• 130°C Insulation system is used. Allowable temperature rise is 95°C.
• Non-current carrying parts bonded to grounding terminal.
• Properly ground the transformer.
• Flip toggle to reset the magnetic circuit breaker.
• If dimmer is used, must be a magnetic, low-voltage dimmer.
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for later use.
• Turn off power at fuse or circuit breaker box before installation or before
doing any maintenance work.
• Installing contrary to instructions may cause unsafe conditions.
• Warning: Risk of fire. Use only the type of lamp and maximum wattage
marked on the fixture.
• To avoid hazards to children, account for all parts and properly dispose of
all packing materials.
• Call the Technical Support department at ConTech Lighting with any
installation questions: 847.559.5500.
120 OR 277V TAP CONNECTION; 12 or 24V
White Feed
COM PRI
Black Feed
120 OR 277V PRI
TRANSFORMER
Green
Striped
Ground
Lead
Green Ground
Internal
Ground
Screw
Circuit Breaker
BOOST TAP CONNECTION; 12 or 24V
White Feed
COM PRI
120 OR 277V PRI
TRANSFORMER
Green
Striped
Ground
Lead
Internal
Ground
Screw
All specifications subject to change without notice.
This document can be recycled.
X2
COM 2
Circuit Breaker
X1
COM 1
Boost Tap
Green Ground
www.contechlighting.com
COM 2
Circuit Breaker
X1
COM 1
Boost Tap
Black Feed
1-847-559-5500
X2
Circuit Breaker
TRNS2 INST