For ConTech Lighting Odyssey AroTech Metal Halide Fixture Adapters: LIR20MHE, LIR39MHE and LIR70MHE
INSTALLATION PROCEDURES
ATTACHING AN AROTECH FIXTURE TO THE ADAPTER:
1. Wire the socket leads from the ballast housing to the extension leads of your AroTech Fixture.
2. Insert the top portion of the extension into the matching shape hole in the ballast housing.
3. Turn the fixture extension clockwise until it is locked into place. It is a tight fit and it must
go over a 1mm metal rise.
1
ATTACHING THE AROTECH ADAPTER TO THE ODYSSEY RAIL:
1. Position and align the tab contacts in the suspension tab with the openings in the rail
insulators (Figure 1).
2. Close the tab side around the rail and screw the cap onto the suspension tab.
3. Turn the fixture on via the switch and electrify the rail.
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for later use.
• Turn off power at fuse or circuit breaker box before installation or before doing any maintenance work.
• Product must be grounded to avoid potential electric shock and any other potential hazards.
• Product must be mounted in locations and at heights and in a manner consistent with its
intended use, and in compliance with National Electrical Code and local codes. Use of
accessory equipment is not recommended.
• Installing contrary to instructions may cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have supply wire rated at 60°C.
Consult a qualified electrician before installation.
• To avoid hazards to children, account for all parts and properly dispose of all packing materials.
• Call the Technical Support department at ConTech Lighting with any installation questions:
847.559.5500.
1.847.559.5500
www.contechlighting.com
All specifications subject to change without notice.
This document can be recycled
LIRMHE INST