1 INSERT LAB TITLE HERE Experiment No.: X Experiment Date: XX/XX/XX Mechanical Measurements Laboratory Report MAE 333 Sec. 01 Insert student 1 name here Insert student 2 name here Outline 2 Introduction Method Results Discussion The Outline slide is typically expected but is not required. Introduction 3 Purpose of experiment was to understand/determine/measure … Experiment was performed by … procedure Used … equipment Introduction – Theory 4 Mercury thermometers use principle of expansion of material with temperature Volumetric coefficient of thermal expansion:[1] 𝛼𝑉 = 1 𝜕𝑉 𝑉 𝜕𝑇 For tube with constant cross-section : ΔL = αV L0 ΔT … References are provided right on same slide as where they are cited. [1] Wikipedia, “Thermal Expansion,” Wikimedia Foundation, Inc., (http://en.wikipedia.org/wiki/Thermal_expansion accessed Sept. 16, 2013) Method – Equipment 5 Thermometer Mercury in tube Scale (image from Mission Restaurant Supply) Something else… Note that figure numbers are not required. Method – Procedure 6 1. 2. Do something Do something else Note: write the procedure as a set of commands. Results 7 Mean and standard deviation as function of number of readings Z (ºK) X (mm) Y (ºC) Temperature Y (ºC) Temperature Z (ºK) X (mm) Discussion 8 It was observed that … Insert answers to questions in lab manual here. It is concluded that … 9 Thank you! 10 Prepare some extra slides in case of questions. Extra Slides Measurements 11 Raw recorded values for … Trial Initial run Data X1 (mm) … Data X2 (mm) Data X3 (mm) Comments Sample Calculations 12 Sample Calculations for xxx X = 5 mm Y 100 X 50 X 100 5 50 5 0 0 0 10C X is the ____ Y is the ____