24Vac 2A Power Supply
MODEL :
TPS24-2AC
© 2012 The contents of
this manual are copyright
and may not be reproduced
without
the
written
permission
of
Tactical
Technologies
Pty
Ltd.
N645
DESIGNED & MANUFACTURED
Installation Manual
®
CAUTION
Equipment must be installed & serviced
by suitably qualified service personnel
in a restricted access area.
Dangerous Voltages Inside !
DANGER
HIGH VOLTAGE
Do not remove covers
No user serviceable parts inside
N645
General
This power supply is designed for indoor use only.
TPS24-2AC is a 24Vac 2A CCTV Power Supply with a single fused output and is provided with a LED
indicator to display circuit status. The TPS24-2AC is particularly handy for installations requiring relatively
high current output for a small number of cameras eg Pan Tilt Zoom or IR Illuminators.
The Tactical 24AC Series includes models ranging from 2A to 20A output, with 1, 2, 4, 10 or 20 individual
fused outputs (model dependant). Check www.tac-tec.com.au or your Tactical Distributor.
Connection
TPS24-2AC has a single fused output with a single set of screw terminals.
In order to provide maximum short circuit protection, it is recommended that the installer assess the
current draw of each device connected to the power supply and fit a fuse of appropriate value to suit.
Ensure that total device current draw does not exceed the rated output of the power supply, remembering
to allow an adequate power margin for equipment cold start.
TPS24-2AC_Rev B.pdf
www.tac-tech.com.au
LAYOUT
TPS24-2AC
A
F
B
C
D
E
DESIGNED & MANUFACTURED
A
Output LED
B
Output Screw Terminals (24Vac 2A)
C
Anti-Surge MOV Network
D
High Efficienct Toroid Transformer
E
Compliance / Date of Manufacture Label
F
Output Fuse (2A)
TPS24-2AC_Rev B.pdf
www.tac-tech.com.au
24Vac
2A Supply
Specifications :
®
( In the interests of product improvement, Tactical reserves the right to change specifications without notice)
TPS24-2AC
Output Voltage
24 Vdc (nominal)
Output Current
2A
Output Channels
1
Output per Channel
2A
Input Voltage
240 Vac / 50Hz
Input Current
300mA RMS @ 240Vac
Input Fuse Rating
not replaceable
Weight
< 2.5Kg
Dimensions
202L x 136W x 82H mm
Safety Standards
AS/NZS61558.2.6.2001 and AS/NZS61558.1.2000
NSW 25042
DOFT Approval No:
EMC Standards
C-Tick
®
www.tac-tech.com.au
Securing Your Power Needs ®
Now and into the Future . . .
Tel: +61 2 8822-1888
5 Butterfield St, Blacktown NSW 2148
Designed & Manufactured
Fax: +61 2 8822-1899