Material Safety Data Sheet
Substance Identification
Identity:
Trade Names:
Manufacturer:
MINERAL PREMIX
Mercer Milling Co., Inc
4698 Crossroads Park Dr
Liverpool, NY 13088
315-701-4482
CAS #
Emergency:
NA
1-800-724-8570
Components and Contaminants
Components:
Mineral Premixes contain some or all of the following:
Ferrous Sulfate, Ferrous Carbonate, Iron Oxide, Manganese Sulfate, Manganous Oxide, Chromium
Tripicolinate, Copper Sulfate, Copper Carbonate, Tribasic Copper Chloride, Copper Oxide, Zinc Oxide,
Zinc Sulfate, Zinc Methionine Complex, Calcium Iodate, Potassium Iodide, EDDI, Pentacalcium
Othoperiodate, Cobalt Carbonate, Cobalt Sulfate, Sodium Selenite, Sodium Molydbate, Sodium Sulfate,
Sodium Bicarbonate, Sodium Chloride, Sulfur, Potassium Sulfate, Potassium Chloride, Potassium
Magnesium Sulfate, Magnesium Sulfate, Magnesium Oxide, Calcium Sulfate, Calcium Carbonate,
Tricalcium Phosphate, Dicalcium Phosphate, Monoammonium Phosphate, Monosodium Phospate,
Ammonium Chloride, Ammonium Sulfate, Clay, Bentonite, Calcium Stearate, Zeolex (Sodium
Aluminosilicate), Zeofree Precipitated Amorphous Silicon Dioxide), Mineral Oil, Vitamins, Natural
Flavors & Artificial Flavors.
8 hr time weighted average of 15mg/m3 total dust & 5/mg/m3 respirable dust.
One or more of the mineral ingredients in this premix exceed 1% of the total mixtures,
therefore, the entire mixture must be classified as hazardous according to 29 CFR 1910.
1210(d)(5)(ii). One or more ingredients may contain silica, which is a suspected carcinogen.
OSHA PEL:
Note:
Physical Data
Boiling Point:
Vapor Pressure:
(mm/Hg):
Vapor Density (Air-1):
Solubility in Water:
Apperance and Odor:
NA
NA
Specific Gravity (H2O=1):
Melting Point (decomposes):
NA
Evaporation Rate (Butyl Acetate=1):
Some components may be water soluble.
White, Brown, red and gray mixtures of mineral.
NA
NA
NA
Fire and explosion Hazard Data
Flash Point:
Flammable Limits:
Extinguishing Media:
Special Fire Fighting Procedures:
Unusual Fire and Explosion Hazards:
Not combustible
LEL NA
UEL NA
Foam, CO2, dry chemical or water.
In the event of fire, wear full protective clothing and NIOSHApproved self-contained breathing apparatus with full face
piece operated in the pressure demand or other positive pressure mode.
Not combustible.
Reactivity Data
Stability:
Conditions to Avoid:
Incompatibility (materials to avoid):
Hazardous Decomposition or Byproducts:
Hazardous Polymerization:
Stable under ordinary conditions of use and storage.
Extreme heat.
NA
May decompose if heated to produce irritating or toxic combustion
products.
Will not occur.
For more specific information, please see MSDS’s for each ingredient in the mixture.
Health Hazard Data
Route of Entry:
INHALATION: May irritate the respiratory tract. May increase the incidence of upper
respiratory infections (pneumonia).
SKIN: May cause irritation.
INGESTION: May cause abdominal pain and nausea.
Cobalt, Copper, and Zinc salts may have oral human lethal doses in the range of 50 to 500
mg/kg.
Health Hazards (Acute and Chronic):
NTP: No
Carcinogenicity:
Signs and Symptoms of Exposure:
Aggravation of Pre-exisiting Conditions:
Emergency and First Aid Procedures:
IARC Monographs: No
Ingestion of large doses of mineral sales usually causes vomiting, but the acute effects are
described as nausea, chills, and diarrhea. Eye or skin irritation may occur following ingredient
contact.
Respiratory irritation could be expected from the inhalation of premix dusts.
IF INHALED, remove to fresh air and seek medical attention for any breathing difficulty.
IN CASE OF SKIN CONTACT, wash with soap & water. Seek medical attention if red &
irritated.
IN CASE OF EYE CONTACT, flush eyes immediately with water for at least 15 minutes.
Seek medical attention if irritation persists.
IF INGESTED, induce vomiting immediately by giving two glasses of water and sticking finger
down throat. Never give anything by mouth to an unconscious person. Call a physician
immediately.
Precautions for Safe Handling and Use
Material Release or Spill Precautions:
Should a spill occur, ventilate area. Clean-up personnel require respiratory
protection. Recover uncontaminated material for use. Vacuum or sweep
remaining material, keeping dust to a minimum.
Dispose of unreclaimable material in a RCRA-approved waste facility.
Protect containers from damage and keep closed when not in use.
Observe good personal hygiene. Wash after handling.
Waste Disposal Method:
Handling and Storing Precautions:
Other Precautions:
Control Measures
Respiratory Protection:
Ventilation:
Protective Gloves:
Eye Protection:
Other Protective Clothing or Equipment:
Work and Hygienic Practices:
Use NIOSH approved particulate respirator if dust generation occurs or is anticipated. OSHA
standard 1910.134 or ANSI Z88.2-1980 specifications are recommended.
A system of local and/or general exhaust is recommended to keep employee
Exposures below the airborne exposure limits. Local exhaust is generally preferred because it
can control the emissions of the contaminant at its source, preventing dispersion of it into the
general work area. Please refer to the ACGIH document, “Industrial Ventilation, A Manual of
Recommended Practices”, most recent edition, for details.
Yes
Safety goggles are recommended.
Use other protective equipment when necessary in order to avoid prolonged exposure to skin.
Observe good personal hygiene. Wash after handling.
SARA Title III Section 313 Supplier Notification
This product may contain the following toxic chemicals subject to the reporting requirements of section 313 of the Emergency
Planning and Community Right-to Know Act of 1986 and of 40 CFR 372.45:
Component
CAS #
Cobalt Compounds
NA
Copper Compounds
NA
Manganous Compounds
NA
Zinc Compounds
NA
 Refer to individual tag and formulation for actual concentrations.
This information must be included in all MSDS’s that are copied and distributed for this material.
% by Weight
1-99%
1-99%
1-99%
1-99%