Disc Sander, Belt Sander & Spindle Sander Safety
Some of the safety rules will apply to all 3 of the sanders.
Disc
Check the abrasive on the sander to make sure it isn’t too coarse or to fine.
The sanding disc must be in good condition. Don’t use the sander if the disc is loose, torn, burned or
clogged.
Check the clearance between the disc and the table about 1/16”. The table should be set as close as
possible without touching the disk at any point.
When you use a guide be sure the guide remains completely clear of the disk.
As always wear eye protection.
Do not wear loose clothing around machines; it could get caught in/on something.
Long hair should be pulled back.
Never stand to the sides of the sanders when turning it on, just in case the disc or belt flies off when
turned on.
Always keep material flat on the table on the downward side of the disk (left side).
Make sure that you use a clamp when sanding something that is small, do not hold it in your hand.
Keep stock moving back and forth across the downward side of the disc. Holding it one place will cause it
to burn.
Never leave the sander running, make sure that it is off and stopped before leaving.
Keep hands and fingers away from the disk so you don’t injure yourself by sanding something off.
Belt
The abrasive belts on the sander have to be in good condition. No clogs, burns, or tears.
Make sure that the arrows on the inside of the belt are going the correct direction.
The sander must be set at the correct tension on the belt.
Be sure the guards are in place and that the table is adjusted correctly about 1/16”.
Switch on the sander and see that it is tracking properly.
Hold the material in your hands and stay clear of the moving belt.
Use the “stop” or “table” to keep the material from being twisted or thrown by the moving belt.
When sanding small pieces use a clamp.
Use a push block when sanding thin material
Don’t get your finger or hands close to the belt.
Use the table or fence to hold the work. Avoid doing free-hand.
Keep the material moving so it won’t get burned.
Use the belt sander with care and caution. It is a powerful tool.
All adjustments must be made with the power off.
Spindle Sander
Keep hands & fingers away from rotation sanding drum or any part.
Make sure sanding drum is not damaged and is properly secured on the spindle and it is not wobbling
(back & forth) movement.
Make sure all work is clear of spindle before you turn it on.
Keep work area clear of clutter.
Do not force work into spindle nice gentle pressure works the best.
Make sure table insert and guards are in place at all times.
Always feed work piece against the direction of the sanding drum rotation.
Clear all debris from table before sanding work piece sawdust, scraps.
Make certain that work piece is properly supported.
Do not use the sander for sanding small pieces, use a clamp instead of your fingers.
Always wear eye protection.