Material Safety Data Sheet
Creative Stone, Inc.
1360 Hwy 71 W. Unit J
Bastrop, TX 78602
MSDS Date:
Product Name:
Manufacturer:
Phone: (512) 303-7866
FAX: (512) 321-9302
4/14/07
Creative Stone (manufactured stone veneer)
Creative Stone, Inc.
1. Product & Company Description
Creative Stone, Inc.
1360 Hwy 71 W. Unit J
Bastrop, TX 78602
For Product Information/Emergency:
(512) 303-7866
2. Hazards Identification
Emergency Overview
Appearance/Odor: Stone Veneer with no odor. Cured concrete product of
various sizes & shapes.
Potential Health Effects
Acute Eye:
Not considered a route of exposure under anticipated use conditions.
Dusts may be irritating to eyes.
Acute Skin:
Dust from this product may cause skin irritation.
Acute Inhalation:
Inhalation of dusts produced during cutting or grinding of this product may
cause irritation of the respiratory tract.
Acute ingestion:
Not considered a route of exposure under anticipated use conditions.
Chronic Exposure:
Chronic respiratory or skin irritations may temporarily worsen from
exposure to dust from this product.
3. Chemical Composition
Component
Pumice*
Expanded Shale/Clay**
Portland Cement
Color Pigments
CAS#
1332-09-8
68334-37-2
Varies
Varies
% Composition
65-75
65-75
20-25
1-5
* Used in light base stone
** Used in dark base stone
As provided this material is in a cured form and the above listed components are
not readily available, however if dusts are generated, these components may be
present.
4. First Aid Measures
Inhalation:
If inhaled, remove the affected person to fresh air. If irritation persists get
medical attention.
Skin exposure:
If irritation develops, flush with water. If irritation persists get medical
attention.
Eye exposure:
Immediately flush eyes with large amounts of water. If irritation persists
get medical attention.
Ingestion:
Ingestion of this material is unlikely. If it does occur seek the advice of
medical personnel.
5. Fire Fighting Measures
Flash point: None
Upper Flammability Limit: Not Applicable
Lower Flammability Limit: Not Applicable
Flammability Classification: Non-Flammable
Auto Ignition Temp.: Not Applicable
Flash Point: Not Applicable
Extinguishing Media: Use extinguishing media appropriate for
surrounding fire.
Special Fire Fighting Procedures: None
Hazardous Combustion: None.
6. Accidental Release Measures
Cleanup & Disposal: Sweep or scoop up material and place in suitable
container for disposal as non-hazardous waste. Discard materials in
compliance with federal, state & local regulations.
7. Handling and Storage
Handling Procedures: No special procedures are required for this
product. Avoid breathing dusts from this product. Avoid dust contact with
eyes & skin. Minimize generation of dust when cutting this product.
Storage Procedures: No special storage procedures required for this
product.
8. Exposure Controls / Personal Protection
General Product Information: Follow all applicable exposure limits if
dusts are generated.
Component Exposure Guidelines:
Color pigments:
ACGIH
OSHA
10/mg/m3 (total dust)
3mg/m3 (respirable)
15mg/m3 (total dust)
5 mg/m3 (respirable)
Portland Cement:
ACGIH
10 mg/m3 (total dust)
3 mg/m3 (respirable)
OSHA
15 mg/m3 (total dust)
5 mg/m3 (respirable)
Expanded Clay / Pumice :
ACGIH
3 mg/m3
OSHA
5 mg/m3
Ventilation: Provide exhaust ventilation or other engineering controls to
keep concentrations of airborne dusts below applicable exposure limits.
Respiratory Protection: An approved, proper fitting dust respirator or
equivalent should be used when dust is present & when cutting, grinding
or altering this product in any way that generates dust. Use respiratory
protection in accordance with OSHA 29 CFR 1910.134 regulations when
workplace conditions warrant respirator use.
Eye Protection: Wear safety glasses with side shields.
Skin Protection: Wear protective gloves as needed.
9. Physical & Chemical Properties
Appearance: Cured Concrete of various colors, shapes & sizes
Odor: None
Physical State: Solid
Vapor Pressure: Not applicable
Vapor Density: Not applicable
Boiling Point: Not applicable
Freezing Point: Not applicable
Specific Gravity: Not applicable
pH: Not applicable
Water solubility: Not applicable
Evaporation Rate: Not applicable
Viscosity: Not applicable
10. Chemical Stability & Reactivity
Chemical Stability: This is a stable material
Conditions to Avoid: Dispersion of dust
Incompatible Materials: None
Hazardous Decomposition Products: None
Hazardous Polymerization: Will not occur.
11. Toxicological Information
Acute Effects: No Data
Chronic Effects: Dusts from cutting or grinding may cause irritation to
eyes & skin. Ingestion may cause irritation of throat. Inhalation may
cause coughing, nose or throat irritation & sneezing. High exposures to
dusts may cause difficulty breathing.
Carcinogenicity: Components not classified as carcinogen
12. Ecological Information
Environmental Toxicity: No data found
Environmental fate: No data found
13. Disposal Considerations
General Product Information: No components identified as hazardous
waste.
Disposal Instructions: What cannot be recycled should be disposed of
as approved by local disposal regulations.
14. Transportation Information
US DOT Information:
Shipping Name: Not regulated
Hazard Class: None
Packing Group: None
Required labels: None
15. Regulatory Information
Federal regulations:
SARA Title III Hazard Classes:
Fire hazard: No
Reactive hazard: No
Release of pressure: No
Acute health hazard: No, unless dust is present
Chronic health hazard: No, unless dust is present
Clean Air Act: None of these components are listed on the
Clean Air Act -1990 Hazardous Air Pollutants List.
16. Other Information
National Paint & Coating Hazardous Materials Identification System- HMIS:
Health Hazard: 0
Flammability: 0
Reactivity: 0
Reasonable care has been taken in the preparation of this information. The information
contained herein is based on the data available to us and is believed to be factual.
Creative Stone, Inc. makes no warranty, expressed or implied regarding the accuracy of
this information or the results obtained from its use.