Racing NSW OCCUPATIONAL HEALTH SAFETY & INJURIES MANAGEMENT SYSTEMS MANUAL Safe Work Method Statement Authorised by: Page: Issue: One Work Method Statement SWMS Form 007.3 Safe Work Method Statement Part 1 Job: HAND SPRAYER (KNAPSACK) CHEMICAL Document Reference No: Department: TRACKS / GARDENS Revision Date: Section: MAINTENANCE Manager’s Approval: Work Area: GROUNDS Manager’s Name: Key Safety Plant / Equipment / (including P.P.E.) Safety Checks / Hazardous Substances Physical inspection of knapsack spraying equipment Inspection of PPE - PVC gloves / overalls / rubber boots / mask Inspection of Work Area Communication and signage Chemical MSDS Spray only when no wind. Codes of Practice Legislation: Applicable to Work? Y/N If Yes, state: External Considerations Person required to carry out work Duties & Responsibilities Qualifications / Experience /Training required to complete work Tracks and garden staff Hand spraying Chemical Certificate Accreditation Copies of relevant Acts, Regulations, Australian Standards and Codes of Practice can be obtained from WorkCover NSW and/ Standards Australia Date Prepared: July 2003 Revision Date: July 2004 Racing NSW OCCUPATIONAL HEALTH SAFETY & INJURIES MANAGEMENT SYSTEMS MANUAL Safe Work Method Statement Authorised by: Page: Issue: One Work Method Statement SWMS Form Safe Work Method Statement Document Reference: Job: Knapsack Spraying No: Procedure (in steps) Possible Hazards in Executing Procedure Check safety gear Exposure Key Safety Controls & Associated Procedures PPE in good condition Check chemical label Exposure to chemical PPE in good condition Placement of signage Public Exposure Signage in place Partly fill tank Prevent chemical reaction Add Chemical Spillage and exposure Check calibration Fill remains of tank Spillage Watch levels Check area to be sprayed Public not exposed signage Check weather Change of weather – do not spray Change in weather – don’t spray check scale Start spraying Wind drift exposing persons Finish spraying Cleaning of tank Spillage and exposure Proper decanting of excess chemical Cleaning of equipment Slipping and falls Well drained area Date Prepared: July 2003 Revision Date: July 2004 Racing NSW OCCUPATIONAL HEALTH SAFETY & INJURIES MANAGEMENT SYSTEMS MANUAL Safe Work Method Statement Authorised by: Cleaning of PPE Excess residue Fill out data book / application diary None Page: Issue: Weather control Copies of relevant Acts, Regulations, Australian Standards and Codes of Practice can be obtained from WorkCover NSW and/ Standards Australia Date Prepared: July 2003 Revision Date: July 2004 One