Assembling the Wall Tower 1. Open out the sheet and lay it down flat, shiny side up with the keyhole fixing slots pointing away from you. 2. Fold the left and right sides along the crease line so they stand upwards at 90 degrees. 3. Overlap the two flat sides to form a semi-cylindrical shape. There are 2 rows of 3 tabs (butterfly clips) that line up with 2 rows of 3 rectangular holes. 4. Take the centre tab (butterfly clip) and push it through the centre rectangular hole it lines up with (slotting the inside part of the tab into the hole first and then pushing through the outside part). 5. Your Flower Tower is now held in a semi-cylindrical shape while you continue to push through the other tabs on the remaining 5 holes. 6. To assemble the base; lay your Flower Tower down with the keyhole fixing slots away from you. Place the semi-circular base just inside your Flower Tower’s flat side first. Place your middle finger inside the nearest planting hole, lift the sheet and ease in the base so it fits tight and locks into the slots. 7. Assemble your watering tube by taking the long tube first and firmly attach the white watering collar to it, then attach one of the short tubes to that followed by the red collar, another tube then the black collar and then the final tube. 8. Locate the completed watering tube firmly into the socket in the base with the long tube at the bottom and the black watering collar and short tube at the top. 9. Your Wall Flower Tower can now be planted up and attached to a wall using two screws through the keyhole fixing slots.