GENERAL CHEMICAL CORPORATION MATERIAL SAFETY DATA SHEET SECTION I PRODUCT NAME OR NUMBER: (as it appears on label) ALKINE 3880 (Soak washer oil remover/rinse aid) MANUFACTURER'S NAME: General Chemical Corporation Only in the Event of CHEMICAL EMERGENCY, Spill, Leak, Fire, Exposure, or Accident Call: ADDRESS (number, street, city, state, zip) 12336 EMERSON DRIVE BRIGHTON, MI 48116 (248) 587 -5600 General Chemical Corp. (800) 424-9300 - Day or Night (703)527-3887 Call Collect from Outside U.S.A HAZARDOUS MATERIALS DESCRIPTION, PROPER SHIPPING NAME, HAZARD CLASS, HAZARD ID NO Liquid Soap- Cleaning Compound. Non-hazadrous by DOT or IMO ADDITIONAL HAZARD CLASSES (as applicable): CHEMICAL FAMILY: Alkali’s FORMULA: Soak tank oil removal. SECTION II - INGREDIENTS CAS REGISTRY NO. %W CHEMICAL NAME(S) 7320-34-5 7 7732-18-5 Balance Tetra Potassium Pyro Phosphate Water & Proprietary ** ** Ingredients are non-hazardous and not regulated. SECTION III - PHYSICAL DATA BOILING POINT: VAPOR PRESSURE: @ F C 212F SPECIFIC GRAVITY (H2O = 1): 1.071.09 VAPOR DENSITY (AIR =1) N.A. N/A PERCENT VOLATILE BY VOL. (%): >70 EVAPORATION RATE (Butyl Acetate = 1): <1 100% PERCENT SOLID BY WEIGHT (%): <10 pH = (neat) [ ] mmHg [ ] psi SOLUBILITY IN WATER: APPEARANCE AND ODOR: Mobil Clear Amber Liquid - mild Soap Odor MATERIAL IS: Approx. >9.0 {LIQUID} SOLID GAS POWDER PASTE SECTION IV - FIRE AND EXPLOSION HAZARD DATA FLASH POINT: (Method used - Literature supplied) None F C FLAMMABLE LIMITS LEL UEL None EXTINGUISHING MEDIA: Dry Chemical, CO2,and Water. SPECIAL FIRE FIGHTING PROCEDURES: Do not direct a solid stream into a burning pool, beacuase this may cause frothing. UNUSUAL FIRE AND EXPLOSION HAZARDS: None. SECTION V - HEALTH HAZARD DATA – ALKINE 3880 EFFECTS OF OVEREXPOSURE (Conditions to Avoid): May cause local irritation when in contact with moisture of the skin and mucous membranes. Aqueous solutions are alkaline and have the same effect. PRIMARY ROUTES OF ENTRY: Inhalation [x ] Skin Contact [x ] THRESHOLD LIMIT VALUE: Undetermined OTHER LIMITS: Undetermined Other (Specify) EMERGENCY AND FIRST AID PROCEDURES: EYES: Immediate irrigation for 30 minutes. SKIN: Thoroughly clean for 30 minutes. INGESTION: Do not induce vomiting. Give large amounts of water. INHALATION: Remove to fresh air. If breathing is labored, call physician. In all cases seek medical advice. SECTION VI - REACTIVITY DATA STABILITY UNSTABLE CONDITIONS TO AVOID: Strong Oxidizing agents. STABLE X INCOMPATIBILITY (Materials to Avoid): Oxidizing Agents. HAZARDOUS DECOMPOSITION PRODUCTS: Combustion may result in undefined organics, oxides of carbon. HAZARDOUS MAY OCCUR POLYMERIZATION WILL NOT OCCUR CONDITIONS TO AVOID: Nitrites should not be added. X SECTION VII - SPILL OR LEAK PROCEDURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Mop up spill. Flush area with water. Place in approved containers for disposal. Keep from entering sewers and waterways. WATER DISPOSAL METHOD: Follow local, state and federal regulations. SECTION VIII - SPECIAL PROTECTION INFORMATION RESPIRATORY PROTECTION: In absence of proper control, NIOSH approved. VENTILATION LOCAL EXHAUST: Yes, at elevated temperatures. SPECIAL: MECHANICAL: OTHER: PROTECTIVE GLOVES: Impervious EYE PROTECTION: Chemical Goggles OTHER PROTECTIVE EQUIPMENT: Face-shield, protective clothing and safety shower. SECTION IX - SPECIAL PRECAUTION PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Prevent contact. Store in ventilated, cool dry area. OTHER PRECAUTIONS: Store above freezing point, do not freeze. Keep containers sealed properly. Wash after handling. Empty containers should be offered for reconditioning after use. Empty containers retain residues and label hazard precautions. DATE ISSUED: 22-AUG-2002 SUPERSEDES: None Information presented herein has been complied to be dependable and is accurate and reliable to the best of our knowledge and belief, but is not guaranteed to be so. Nothing herein is to be construed as recommending any practice or any product violation of any patent or in violation of any law or regulation. It is the user's responsibility to determine for him/herself the suitability of any material for a specific purpose and to adopt such safety precautions as may be necessary. We make no warranty as to the results to be obtained in using any material and, since conditions of use are not under our control, we must necessarily disclaim all liability with respect to the use of any material supplied by us.