The following list was compiled in March 1997, and is not exhaustive.
1. J. Baczynski, ‘Computer controlled vibrating capacitor technique for determining work
function’, Rev.Sci.Instrum., 59, 2471 (1988).
2. D. Baikie, H. Van der Werf et. al., ‘Integrated automatic modular measuring system’,
Rev.Sci.Instrum., 59(9) (1988).
3. D. Baikie, H. Van der Werf et. al., ‘Automatic Kelvin probe compatible with ultrahigh vacuum’,
Rev.Sci.Instrum., 60(5). (1989)
4. D. Baikie, E. Venderbosch et. al., ‘Analysis of stray capacitance in the Kelvin method’,
Rev.Sci.Instrum., 62(3) (1991).
5. D. Baikie, S. Mackenzie et. al., ‘Noise and the Kelvin method’, Rev.Sci.Instrum., 62(5) (1991).
6. D. Baikie and H. Bruggink, ‘Characterisation of surface preparation methods using a novel
scanning Kelvin probe’, Mat.Res.Soc.Symp.Proc.Vol.315 (1993).
7. D. Baikie and H. Bruggink, ‘Characterisation of oxides and thin films’,
Mat.Res.Soc.Symp.Proc.Vol.309 (1993).
8. H. Baumgartner, H. D. Leis, ‘Micro Kelvin probe for local work function measurements’,
Rev.Sci.Instrum., 59, 802, (1988).
9. K. Besocke and S. Berger, ‘Piezo-electric driven Kelvin probe for contact potential difference
studies’, Rev.Sci.Instrum., 47(7) (1976)
10. J. S. W. de Boer et. al., ‘Analysis and improvement of the Kelvin method for measuring
differences in work function’, Rev.Sci.Instrum., 44, 1003 (1973).
11. P. Craig and V. Radeka, ‘Stress dependence of contact potential: the a.c. Kelvin method’,
Phys.Rev.Lett., 22, 700, (1969).
12. P. Craig and V. Radeka, ‘Stress dependence of contact potential: The a.c. Kelvin method’,
Rev.Sci.Instrum., 41, 258 (1970).
13. S. Danyluk, ‘A UHV guarded Kelvin probe’, J.Phys.E., 5, 478 (1972).
14. L. T. Han and F. Mansfield, ‘Scanning Kelvin probe analysis of welded stainless steel’, 1997,
Corros.Sci., 39(1), 199 (1997).
15. K. Henning, T. Hochwitz et al., ‘Two dimensional surface dopant profiling in silicon using
scanning Kelvin probe microscopy’, J.Appl.Phys., 77(5) (1995).
16. Lord Kelvin, Phil.Mag., 46, 82 (1898).
Í EG&G Instruments
Doc. No: SKPMAN101
Issue No: 1
SKP100E Operator Manual
Date: 12/02/16
Page: Page 2 of 3
17. Kikukawa, S. Hosaka et. al., ‘Silicon pn junction imaging and characterisations using
sensitivity enhanced Kelvin probe force microscopy’, Appl.Phys.Lett., 66(25) (1995).
18. A. Leng and M. Stratmann, ‘The inhibition of the atmospheric corrosion of iron by vapour
phase inhibitors’, Corros.Sci., 34, 1657 (1993).
19. M. Nonnenmacher, M. P. O’Boyle et. al., ‘Kelvin force microscopy’, Appl.Phys.Lett., 58, 2921
(1991).
20. J. H. Parker and R. W. Warren, ‘Kelvin device to scan large areas for variation in contact
potential’, 1962, Rev.Sci.Instrum., 33, 948 (1962).
21. B. Ritty, F. Wachtel et. al., ‘New application of the Kelvin method involving the scanning of
the bucking voltage’, Rev.Sci.Instrum., 51, 1421 (1980).
22. B. Ritty, F. Wachtel et. al., ‘Conditions necessary to get meaningful measurements from the
Kelvin method’, Phys.E:Sci.Instrum., 15 (1982)
23. F. Rossi, ‘Contact potential measurement: Spacing dependence errors’, Rev.Sci.Instrum., 63,
4174 (1992).
24. M. Stratmann, K. Bohnenkamp et. al., ‘The influence of copper on the atmospheric corrosion
of iron’, Corr.Sci., 27, 905 (1987).
25. M. Stratmann and H. Streckel, ‘The investigation of the corrosion of metal surfaces, covered
with thin electrolyte layers - A new experimental technique’, Ber.Bunsenges.Phys.Chem., 92,
1274 (1988).
26. M. Stratmann and K. Hoffmann, ‘In situ Mößbauer spectroscopic study of reactions within rust
layers’, Corros.Sci., 29, 1329 (1989).
27. M. Stratmann and H. Streckel, ‘On the atmospheric corrosion of metals which are covered
with thin electrolyte layers - II. Experimental results’, Corro. Sci., 30(6/7), 697 (1990).
28. M. Stratmann and H. Streckel, ‘On the atmospheric corrosion of metals which are covered
with thin electrolyte layers - I. Verification of the experimental technique’, Corro. Sci., 30(6/7),
681 (1990).
EG&G Instruments
106737259
Í EG&G Instruments
Doc. No: SKPMAN101
Issue No: 1
SKP100E Operator Manual
Date: 12/02/16
Page: Page 3 of 3
29. M. Stratmann and H. Streckel, ‘On the atmospheric corrosion of metals which are covered
with thin electrolyte layers - III.’, Corros.Sci., 30(6/7), 715 (1990).
30. M. Stratmann, H. Streckel et. al., Short Communication - ‘A new technique able to measure
directly the delamination of organic polymer films’, Corro. Sci., 32(4), 467 (1991).
31. M. Stratmann and W. Fürbeth, ‘The scanning Kelvin probe - an in-situ technique for
characterising the delamination of protective organic coatings’, NACE (1995).
32. N. A. Surplice and R. J. D’arcy, ‘A critique of the Kelvin method of measuring work functions’,
J.Phys.E., 3, 477 (1970).
33. W. A. Zisman, Rev.Sci.Instrum., 3, 367 (1932).
EG&G Instruments
106737259