MATERIAL SAFETY DATA SHEET
PRODUCT NAME:
REVISION DATE:
Poly-Gel
October 12, 2009
For Chemical Emergency (Spill, Leak, Fire, Exposure or Accident)
CALL CHEMTREC Day or Night 800-424-9300
For International, Call 703-527-3887 (Collect Calls Accepted)
** FOR INDUSTRIAL USE ONLY **
Section 1 - Product Information
Chemical Name: Sodium Montmorillonite
Formula: NA
DOT Hazard Class: Not Regulated
CANADIAN, ADR, ICAO/IATA, SEA TRANSPORTATION, IMDG ALL NOT RESTRICTED
Flash Point:
Melting Point:
Color:
Physical state:
Solubility in Water:
ND
ND
Off-white powder
solid
Insoluble
Material
1) SODIUM MONTMORILLONITE
2) Crystalline Silica as Quartz
Section II - Physical Data
Autoignition Temp.
pH range:
Odor:
Specific Gravity
Evaporation Rate:
Section III - Ingredients
Cas #
%
1302-78-9
>95
14808-60-7
2-6
ND
8-10
None
2.45-2.55
ND
TLV(units)
5-15mg/m3
Hazard
See Section V
Section IV - Fire & Explosion Hazard Data
Extinguishing Media: Water spray, Foam, CO2, Dry Chemical
Special Fire Fighting Procedures: NA
Fire & Explosion Hazards: None, product will not burn nor support combustion
*Additional information will be provided in a medical emergency to qualified medical personnel.
Section V - Health Hazard Data
Does product contain any OSHA, NTP or IARC Carcinogens? Bentonite is not listed but there is sufficient evidence
in humans for carcinogenicity
First Aid: Eyes: Flush thoroughly with running water at least 15 minutes. Get medical attention if irritation persists.
Skin: Remove contaminated clothing and wash contact area with soap and water for 15 minutes.
Inhalation: In case of exposure to a high concentration, remove person to fresh air. If breathing has stopped,
administer artificial respiration and seek medical attention.
Ingestion: If appreciable quantities are swallowed, seek medical attention.
Nature of Hazard (Physiological Effects)
Nature of Hazard (Physiological Effects)
Economy
Polymers & Chemicals
P.O. Box 450246
Houston, TX 77245-0246
USA Toll free: (800) 231-2066
Phone: (713) 723-8416
Fax: (713) 723-1845
URL: www.EconomyPolymers.com
E-mail: economy@economypolymers.com
MEDICAL CONDITIONS GENERALLY RECOGNIZED AS BEING AGGRAVATED BY EXPOSURE: None
Known
PRIMARY ROUTE OF ENTRY: Following standard industrial hygiene and recommended procedures, entry of the
compound into the body is not expected.
CANCER INFORMATION: Crystalline Silica: Excessive exposure, over prolonged periods causes lung damage
commonly known as “silicosis.” The International Agency for Research on Cancer has concluded crystalline silica,
inhaled in excessive amounts, in the form of quartz or cristobalite, from occupational sources, is carcinogenic to
humans.
Section VI - Reactivity Data
Stability: Stable Hazardous Polymerization: Will not occur
Conditions to avoid: None
Incompatibility (Materials to Avoid): None
Hazardous Decomposition Products: Fumes produced when heated to
decomposition may include: oxides of carbon.
NFPA RATINGS:
HEALTH 0,
FLAMMABILITY
0,
REACTIVITY
0
HIMS RATINGS:
FLAMMABILITY 0,
REACTIVITY
0,
HEALTH
0
Section VII - Spill or Leak Procedures
*Stop flow and contain spill by diking, sandbags, etc.
*Eliminate all ignition sources.
*Incinerate using afterburner and scrubber
*Use skin protection (as per section VIII) *Absorb on inert material and scraps up or shovel into drums
*Observe federal spill and water quality regulations.
Section VIII - Special Protection Information
Air Exposure Recommendations
Gas, Fumes, Mists
Special Thermal
Normal Use
Exceeds TLV
Spray Application
General Ventilation
General Ventilation
General Ventilation
3*
3*
3*
*Respiratory protection codes:
1. None Needed
2. Particle-removing, air purifying respirator (Dusk Mask)
3. Gas and vapor-removing, air purifying respirator (Canister)
4. Full face mask, positive pressure-demand type (Air Supplied)
Eye Protection: Goggles, Face Shield
Skin Protection: Neoprene Gloves, Nitrile Gloves
Other Protective Equipment: Chemical Resistant Apron, Shoes
Section IX - Special Precautions
Wear eye and skin protection. Store in dry place. Keep container closed to avoid moisture pickup. Material slippery
when wet.
Section X – Miscellaneous
This product is on the following inventories
US TSCA,
EUROPEAN EINECS
KOREAN
CANADIAN DSL
AUSTRALIA AICS
PHILIPPINE
CHINESE
NEW ZEALAND PENDING
WHMIS: Contains >0.1% Crystalline Silica
Labels: None Required
Economy
Polymers & Chemicals
P.O. Box 450246
Houston, TX 77245-0246
USA Toll free: (800) 231-2066
Phone: (713) 723-8416
Fax: (713) 723-1845
URL: www.EconomyPolymers.com
E-mail: economy@economypolymers.com