Coming soon - Moonlite CHL Model 2.5” large format focusers for EDGE scopes using a focal reducer These new CHL 2.5” large format focusers feature a special low profile hybrid design to allow focal reducers to be used inside the focuser. We make 3 versions, one for EDGE 8” using the .7” EDGE reducer, one for the EDGE 9.25” using the Lepus Telecompresser #19410, and a version for the EDGE 11”/ 14” using the large EDGE .7 reducer. Same options and cost as our regular CSL model focusers. Moonlite CHL focuser configuration for EDGE 8” scope Color = All colors available Body = 1.85” thin style with new bearing collimation system Bottom flange = Special EDGE 8” Focal reducer flange with 2”SCT thread system Upper flange = .85” standard thickness Drawtube = .7” travel 68mm thread top style Knob/Motor = All options, manual and motor system can be installed Focuser can be used with or without the .7 reducer. The reducer is installed in to the bottom of the focuser flange, then the whole unit is threaded on to the visual back. Distance from the reducer to thetop of the drawtube is only 1.6” racked in , to 2.3” racked out. That allows the system to meet the 105mm spacing from the reducer to the CCD sensor easily. A clear adapter is included free with EDGE 8” focuser and is to be installed in bottom of the focuser flange if the .7 reducer is not used. This allows the focuser and scope to operate in native mode; however distance from visual back to camera is much greater when the reducer is not being used. This focuser is primary designed to operate with the .7 reducer installed. Moonlite CHL focuser configuration for EDGE 9.25” scope Color = All colors available Body = 1.85” thin style with new bearing collimation system Bottom flange = Special EDGE 9.25” Focal reducer flange for Lepus Telecompressor Upper flange = .55” thin version Drawtube = 1” travel 68mm thread top style Knob/Motor = All options, manual and motor system can be installed The CHL model focuser for the EDGE 9.25” has a special designed lower flange that allows the Lepus Telecompressor to be installed inside the focuser. Once the lens is placed in to the flange, the focuser is then threaded on to the visual back. That will secure the focuser and lens in the exact required position. Please note the gold ring is discarded. A spacer ring also comes with the lens so it can be used on the 11” EDGE scope as well. However Celestron makes a reducer for the 11”, so the spacer is really not requires. This solution is intended for the 9.25”. Distance from the telecompressor to the top of the drawtube fully racked in is 2.93”. That allows the system to meet the 105mm spacing from the reducer to the CCD sensor. The focuser can also be used without the telecompressor installed. Moonlite CHL focuser configuration for EDGE 11” and 14” scopes Color = All colors available Body = 1.85” thin style with new bearing collimation system Bottom flange = Celestron 3 ¼” thread regular profile Upper flange = .55” thin version Drawtube = .7” travel 68mm thread top style Knob/Motor = All options, manual and motor system can be installed The CHL model focuser for the EDGE 11” and 14” has a special low profile design. It allows enough space so the large .7 reducer can install on the visual back of the scope, then the Moonlite CHL focuser threads on to the large reducer using the 3 ¼” large thread connection. It allows the 146mm spacing requirements to be meet easily.