Rexbee Node Retrieved – User terminal V1.01
1. Function simple introduction
Node address table lead-in
User verify
Node seek and parameter configuration
Monitor authorized node
2. Operation steps
2.1. Installation of user terminal
Open “Rex_App_Node_Install.exe”， install as instruction（normally
press “Next step”），Open “Rex APP Node” after installation.
2.2. User node address lead-in
Open user terminal, tips of choosing verification and communication
Verification : Local and Online ，choose Local。
Communication ：Serial Port means communicate with COO by serial port。
TCP/IP means communicate with COO by internet.
User supply the nodes address which need to be retrieved to our FAE, we will
create a relative node table and user verify information. When open the user terminal,
it will remind user to lead-in the Mac Address List File (user node address
table)(*.bin)。
Press“Load”，lead-in the node address table，press “Next” to verify
the user。
2.3. User verify
Input（User Name）and （Password），press “Enter”。
2.4. Retrieve node and reset it.
Start：connect COO。
Stop：disconnect COO。
Monitor：monitor node data。
Find：operation of finding node。
Config：operation of configure。
Node Address List : retrievable node list
Retrieving steps：
1、Press “config” to set user terminal’s serial port, server
terminal’s IP and port, progress configuration of server port.
2、Press “Start” to communicate with COO。
3、Press “Find” to callout retrieving operation interface.
4、Press “Node State” to choose finding node’s status. Not Encrypt –
without encryption；
Encrypting；Encrypted。Press “Scan Time”to input scan times of single
channel. Press“Channel” to choose the scan channel。
5、Press“Scan” to scan the chosen channel, it will list all scanned nodes
in the middle table.
6、Choose nodes which need to be reset parameter, then press “Reset”.
the node which is reset and get feedback normally will be marked in
green。
The node will reset the parameter after 30s ~ 60s received the reset
command, and restart then. User can use “Not Encrypt”mode to check
again, whether the node is reset successfully。
2.5. Monitor node data
Limited to data from lead-in node。
3. Attention
1. User need to know the status of the node which is need to retrieve,
so as to determine which retrieving mode need to be used。
2. User terminal don’t support windows XP and lower system。