GOVERNMENT OF PAKISTAN
MINISTRY OF FINANCE, ECONOMIC AFFAIRS, REVENUE AND STATISTICS
(REVENUE DIVISION)
Islamabad, the
30th June , 2015.
NOTIFICATION
(CUSTOMS)
S.R.O.601(I)/2015.- In exercise of the powers conferred by sub-section (3) of
section 18 of the Customs Act,1969 (IV of 1969), the Federal Government is pleased to
direct that the following further amendments shall be made in its Notification No.
S.R.O.568(I)/2014, dated the 26th June, 2014, namely:-
In the aforesaid Notification, (1)
in the Table, in column (1),-
(i)
after S.No.197 and the entries relating thereto in columns (2), (3)
and (4), the following new S.No. and the entries relating thereto
shall be inserted, namely:“197A. 3402.2000 Preparations put up for
retail sale
197B. 3402.9000 Other
5
197C.
10
197D.
(ii)
4011.2090 Other
63.01
Blankets and travelling rugs
5
5”;
after S.No.204 and the entries relating thereto in columns (2), (3)
and (4), the following new S.Nos. and the entries relating thereto
shall be inserted, namely:“204A.
6907.1000 Tiles, cubes and
similar
articles,
whether
or
not
rectangular,
the
largest surface area
of which is capable
of being enclosed in
15
204B.
204C.
(iii)
a square the side of
which is less than 7
cm
6907.9000 Other
6908.9090 Other
15
15”;
after S.No.212 and the entries relating thereto in columns (2), (3)
and (4), the following new S.No. and the entries relating thereto
shall be inserted, namely:“212A. 7204.4940 Waste
and
Compressor
(iv)
scrap
of
5”;
after S.No.220 and the entries relating thereto in columns (2), (3)
and (4), the following new S.No. and the entries relating thereto
shall be inserted, namely:-
(v)
“220A.
72.16
Angles, shapes and sections
of iron or non-alloy steel
15;
220B.
72.17
Wire of iron or non-alloy steel
15”;
S.No.221 and the entries relating thereto in columns (2), (3) and
(4), shall be omitted;
(vi)
S.No..222 and the entries relating thereto in columns (2), (3) and
(4), shall be omitted;
(vii)
S.No..223 and the entries relating thereto in columns (2), (3) and
(4), shall be omitted;
(viii)
after S.No.224 and the entries relating thereto in columns (2), (3)
and (4), the following new S.No. and the entries relating thereto
shall be inserted, namely:“224A.
72.25
Flat rolled products of other
alloy steel, of a width of 600
mm or more
17.5;
224B.
72.26
Flat-rolled products of other
alloy steel, of a width of less
than 600 mm
17.5”;
(ix)
against S.No.225 and the entries relating thereto in columns (2), (3)
and (4), the following respectively shall be substituted, namely:“225.
(x)
72.27
Bars and rods, not rolled, in
10;
irregularly wound coils, of
other alloy steel
S.Nos 226 and 227 and the entries relating thereto in columns (2)
,(3) and (4), shall be omitted;
(xi)
against S.No. 229, in column (4), for the figure “15”, the figure “20”
shall be substituted;
(xii)
S.No.229B and the entries relating thereto in columns (2), (3) and
(4), shall be omitted;
(xiii)
against S.No.229C, in column (4), for the figure “15”, the figure
“17.5” shall be substituted; and
(xiv) after S.No.229D and the entries relating thereto in columns (2), (3)
and (4), the following new S.No. and the entries relating thereto
respectively shall be inserted, namely:-
(xv)
“229E.
73.12
229F.
73.18
Standard wire, ropes, cables,
plaited bands, slings and the
like, of iron or steel, not
electrically insulated
10;
Screws, bolts, nuts, coach
10”;
screws hooks, rivets, cotters,
cotter-pins,
washers
(including spring washers)
and similar, article, of iron or
steel.
after S.No.238 and the entries relating thereto in columns (2), (3)
and (4), the following new S.No. and the entries relating thereto
respectively shall be inserted, namely:“238A. 8212.1000 Razors
238B.
8212.2000 Safety
razor
including
razor
blanks in strips
5
blades,
blade
5
“238C.
(xvi)
83.11
Wire, rods, tubes, plates,
electrodes
and
similar
products, of base metal or
of metal carbides, coated
or cored with flux material,
of a kind used for
soldering, brazing, welding
or deposition of metal or of
metal carbides; wire and
rods, of agglomerated base
metal powder, used for
metal spraying.
10”;
after S.No.309 and the entries relating thereto in columns (2), (3)
and (4), the following new S.No. and the entries relating thereto
respectively shall be inserted, namely:“309A. 9503.0010 Wheeled toys designed to
be ridden by children (for
example,
tricycles,
scooters, pedal cars); dolls'
carriages.
309B.
(2)
9503.0090 Other
5
5”; and
in paragraph 2,(i)
in clause (h), for the figure “41”, the figure “16”, shall be substituted;
(ii)
for clause (i), the following shall be substituted, namely:“(i) imports of special steel round bars and rods of non-alloy steel
exceeding diameter 75 mm (PCT code 7214.9990) under Sr.No.14 of
Notification No. S.R.O.565(I)/2006, dated the 5th June, 2006; and
(iii)
after clause (i) , amended as aforesaid, the following new clauses shall be
added, namely:“(j) ) imports under PCT codes 7312.9010, 7318.1520 and 7318.1620;
“(k) imports of non-grain oriented
electrical steel sheets (PCT codes
7225.1900 and 7226.1900) under Sr.No.18 and 25 of Notification No.
S.R.O.565(I)/2006 dated 5th June, 2006;
(l) imports of grain oriented
electrical steel sheets (PCT codes
7225.1100 and 7226.1100) under Sr.No.24 of Notification No.
S.R.O.565(I)/2006 dated the 5th June, 2006; and
__________________________________________________________________________
[C.No.6(2)/2014-CB.Pt.]
(NISAR MUHAMMAD)
Additional Secretary