CAD Software as a Teaching and Learning Tool © PDST, 2010 The ThePDST PDSTisisfunded fundedby bythe theDepartment DepartmentofofEducation Educationand andSkills Skills under underthe theNational NationalDevelopment DevelopmentPlan, Plan,2007-2013 2007-2013 2 Draft Guidelines for Teachers 2006 Design and Communication Graphics seeks to build on the strengths of its predecessor Technical Drawing, which had a strong reliance on the underlying principles of plane and solid geometry. Draft Guidelines for Teachers 2006 The advancement of lifelong learning skills The power of parametric modelling for the teaching of plane and descriptive geometry should be fully utilised through the incorporation of a data projector as an essential piece of equipment for the Design and Communication Graphics classroom. Our Approach HANDS ON THINKING OUTSIDE THE BOX Key Geometric Principles Plan for the Night • • • • • • Transformation Geometry Conic Sections/Ellipse Commands Pictorial Projection/Axonometric Intersection of Surfaces DCG 2012 Intersection of Surfaces Transformation Geometry Conic Sections/Ellipse • Create a teaching and learning model for one the following areas of the Ellipse – Major and Minor Axis – Ellipse as a Conic Section – Construction Methods – Introduction to the Ellipse – Tangent and Normal – Other Time 45 minutes Groups of Two People Commands • Measure • 3 D Sketch • Four View • Insert Image/Sketch • Roll Back • Convert Entities • Edit Sketch • Edit Feature Pictorial Projection /Axonometric SolidWorks Drawing Sketch & Layers Intersection of Surfaces Intersection of Surfaces