Getting Started
Make sure you have completed the measurements required before
adjusting the simulator to use the sensor array.
Sampling and Saving a Seat
•Double click on the short-cut to s2k
icon.
•Select sample tab
•Select sample seat
•Select start sample
•Position sensor array at the starting
position on the cushion
•Starting position for seat is at the front
of cushion
•Move the sensor array along the
simulator in half-inch increments
•Once sensing is completed double click
on the stop sample button
•Click on the done button
•Under the file tab, select save seat
•Name file using signature file format
(XX001s.dat)
Sampling and Saving a Back
•Select sample tab
•Select sample back
•Select start sample
•Fully recline the simulator to the
180° position
•Position sensor array at the
starting position on the cushion
•Starting position for the back is at
the bottom of the back
•Move the sensor array along the
simulator in half-inch increments
•Once sensing is completed double
click on the stop sample button
•Click on the done button
•Under the file tab, select save seat
or back
•Name file using signature file
format (XX001b.dat)
Shape Save Verification
•Verification of the saved shape can be
found along the blue line at the top of the
window
Saving to a Disk
• I do not recommend saving the shape to a
disk using the Signature software because
you can over write a good shape if you
select the incorrect option
• Windows explorer is the simplest way to
save to a disk without the ability to over
write the file
Saving to a Disk
• Using windows explorer
– Double click windows
explorer icon
– Normally opens to “My
Documents”
– Find folder where cushion
shapes are saved by
clicking on column on left
side of screen
– Once files are located
– Click on file once so that it
is highlighted
Saving to a Disk
– Then go to top of screen
and hit edit
– Then copy Then find the
folder titled My Computer
and click on it
– Then select 3 ½” floppy (a:)
– Then go to top of screen
and hit edit
– Then select paste
– It should tell you the file is
being copied to the disk