WhisperGreen Select Wiring Configurations
1) Manual Control Wiring Diagram
(ON/OFF or Boost from Low Speed to
High Speed)
•
Connect red Signal Wires directly to
Wall Switch
All modules are functional when
installed
•
•
DO NOT connect Signal Wires to Power
2) Automatic Control Wiring Diagram
(Wire direct to power supply)
•
•
Signal Wires must be capped separately
Must have Motion or Condensation
module for Fan to Operate in High Speed
•
DO NOT connect Signal Wires to Power
3) Basic Wiring Diagram
(ON/OFF for Single Speed)
•
Signal Wires must be capped
separately
•
No Modules will function when fan
is switched off
WIRING METHOD 1 – For MANUAL CONTROL & All Plug & Play modules
Power
Fan
NOTE: This wiring method for MANUAL CONTROL of the fan.
Red wires loop to Single Pole switch.
WIRING METHOD 2 – For AUTOMATIC CONTROL only (All Plug & Play Modules)
Power
Fan
NOTE: This wiring method is for AUTOMATIC CONTROL of the
fan (motion sensor/humidity control ONLY). No manual control.
Red wires must be capped separately.
WIRING METHOD 3 – For On/Off Operation Only (No plug in modules)
Power
Fan
NOTE: This wiring method may cause Plug & Play modules
to not function correctly. Red wires must be capped
separately