CHAPTER 12 and 16
Electrical Properties / Corrosion and Degradation
12.1 (a) Compute the electrical conductivity of a cylindrical silicon specimen 5.1 mm (0.2in.) in diameter and 51
mm (2 in.) in length in which a current of 0.1 A passes in an axial direction. A voltage of 12.5 V is measured across
two probes that are separated by 38 mm (1.5 in.).
(b) Compute the resistance over the entire 51 mm (2 in.) of the specimen.
12.12 (a) Calculate the number of free electrons per cubic meter for gold assuming that there are 1.5 free electrons
per gold atom. The electrical conductivity and density for Au are 4.3 107 (-m)-1 and 19.32 g/cm3, respectively.
(b) Now compute the electron mobility for Au.
12.16 Tin bronze has a composition of 92 wt% Cu and 8 wt% Sn and consists of two phases at room temperature:
an phase, which is copper containing a very small amount of tin in solid solution, and an phase, which consists
of approximately 37 wt% Sn. Compute the room temperature conductivity of this alloy given the following data:
Density (g/cm3)
α
Electrical Resistivity
(Ω · m)
1.88 × 10–8
5.32 × 10–7
8.25
Phase
8.94
16.2 (a) Write the possible oxidation and reduction half-reactions that occur when magnesium is immersed in each
of the following solutions:
(i) HCl, (ii) an HCl solution containing dissolved oxygen, (iii) an HCl solution
containing dissolved oxygen and, in addition, Fe 2+ ions.
(b) In which of these solutions would you expect the magnesium to oxidize most rapidly? Why?
16.6 An electrochemical cell is composed of pure copper and pure lead electrodes immersed in solutions of their
respective divalent ions. For a 0.6 M concentration of Cu2+, the lead electrode is oxidized, yielding a cell potential
of 0.507 V. Calculate the concentration of Pb2+ ions if the temperature is 25°C.
16.8 For the following pairs of alloys that are coupled in seawater, predict the possibility of corrosion; if corrosion
is probable, note which metal/alloy will corrode.
(a) Aluminum and magnesium
(b) Zinc and a low-carbon steel
(c) Brass (60 wt% Cu–40 wt% Zn) and Monel (70 wt% Ni–30 wt% Cu)
(d) Titanium and 304 stainless steel
(e) Cast iron and 316 stainless steel