AIN SHAMS UNIVERSITY
Faculty of Engineering
Prof. Wael Fikry
Physics of Semiconductors
and Dielectrics-PHM224s
2026
Problem Set 2: Semiconductors under thermal equilibrium
Put (T) on the true statement or (F) on the false statement. You should provide the
correct statement for the false one.
1.
The effective mass of an electron in a semiconductor material takes into account the internal
influences of the fixed lattice so that electron can be treated as almost free.
2.
The effective mass accounts for scattering due to lattice vibration or any other type of scattering
3.
In all cases, the effective mass of a hole is higher than that of an electron.
4.
GaAs and Si differ significantly in their optical properties
5.
The probability that an electron may occupy an allowed state at the Fermi level is dependent on
temperature.
6.
The area under the density of states curve in the conduction band represents the total number of free
electrons per unit volume
7.
Energy levels below the Fermi level are more likely to be occupied with holes than those above the
Fermi level.
8.
The mass action law (n p = ni2 ) is valid in all semiconductors under steady state condition.
9.
The mass action law is valid at thermal equilibrium in intrinsic semiconductor only.
10. The energy gap of a semiconductor material increases with increasing temperature.
11. The effective density of valence band states increases linearly with increasing temperature
12. In an n-type semiconductor, the Fermi level moves closer to the middle of the energy gap as the
temperature increases.
13. When an intrinsic semiconductor is doped with ND donors, the new electron concentration is n = ni +
ND .
14. If a semiconductor is doped with ND donor atoms and NA acceptor atoms, the electron concentration
is equal to
1
2
2
N D − N A N D − N A
2
n=
+
+ ni
2
2
15. If a semiconductor is doped with ND donor atoms and NA acceptor atoms such that ND =NA then the
equilibrium electron and hole concentrations as given by: n = p = ni .
16. Charge neutrality in a semiconductor at any temperature can be formulated as follows: n + NA= p + ND
17. The electron and hole concentration expressions, n=Nc exp [(Ef –Ec)/kT] and p=Nv exp [(Ev–Ef)/kT],
are valid only if Ef lies in the forbidden gap more than 3kT from either band edge
18. The intrinsic carrier concentration of a semiconductor increases as its energy gap decreases.
1
19. Certain insulators and semiconductors are transparent to visible light because of their high-energy gap.
20. The difference between the Fermi level and the conduction band edge Ec varies from one point to
another inside a non-uniformly doped semiconductor.
21. The injection of carriers increases the electron-hole densities such as np > ni2
22. At any absolute temperature (T) between 200K and 400K, if the doping concentration of highly
doped non-degenerate silicon material is doubled the difference between the bottom of the
conduction band and the Fermi level is reduced by 0.693 kT eV.
23. The electron and hole concentrations of a silicon wafer doped with 1015cm-3 donor atoms at 250 K is
equal to 1015 and 105 cm-3 respectively.
24. As the temperature increases, the Fermi level in extrinsic semiconductor approaches the intrinsic
level.
25. Silicon is a direct band gap semiconductor material.
Choose the best correct answer. Show your working of numerical problems
1.
For the two conduction bands A and B shown in figure, the electron effective
mass in band B is ………. that in band A.
(a) higher than
(b) smaller than
(c) equal to
(d) of unknown relation to
2.
Doping silicon with Aluminum results in …………..
(a) n-type semiconductor
(b) p-type semiconductor
(c) intrinsic semiconductor
(d) non-conducting material
3.
Doping Germanium with Arsenic results in …………..
(a) n-type semiconductor
(b) p-type semiconductor
(c) intrinsic semiconductor
(d) non-conducting material
4.
Doping silicon with Gallium results in …………..
(a) n-type semiconductor
(b) p-type semiconductor
(c) intrinsic semiconductor
(d) non-conducting material
5.
Doping silicon with phosphorous results in …………..
(a) n-type semiconductor
(b) p-type semiconductor
(c) intrinsic semiconductor
(d) non-conducting material
6.
In an intrinsic semiconductor ……………………..
(a) There is no allowed energy levels between Ec and Ev.
(b) There is an allowed energy level which is little above Ev.
(c) There is an allowed energy level which is little below Ec.
(d) There is an allowed energy level which is near the middle between Ec and Ev .
7.
In an n-type semiconductor ……………………..
(a) There is no allowed energy levels between Ec and Ev.
(b) There is an allowed energy level which is little above Ev.
(c) There is an allowed energy level which is little below Ec.
(d) There is an allowed energy level which is near the middle between Ec and Ev .
8.
In a p-type semiconductor ……………………..
(a) There is no allowed energy levels between Ec and Ev.
(b) There is an allowed energy level which is little above Ev.
(c) There is an allowed energy level which is little below Ec.
(d) There is an allowed energy level which is near the middle between Ec and Ev .
2
9.
The electron and hole concentrations are equal to zero ……….…….
(a) in an intrinsic semiconductor.
(b) in an extrinsic semiconductor.
(c) in a semiconductor at 0 K temperature.
(d) in a semiconductor at very high temperature.
10. In an intrinsic semiconductor, if n and p are the electron and hole concentrations, …...
(a) n must be zero
(b) p must be zero
(c) n and p must be equal
(d) n and p must not be equal
11. In an n-type semiconductor, if n and p are the electron and hole concentrations, …...
(a) n must be zero
(b) p must be zero
(c) n is smaller than p
(d) n is larger than p
12. In a p-type semiconductor, if n and p are the electron and hole concentrations, …...
(a) n must be zero
(b) p must be zero
(c) n is smaller than p
(d) n is larger than p
13. In a particular semiconductor the probability of electrons occupying states at energy kT above
the bottom of the conduction band is e-10. The position of the Fermi level in the given material is
(a) Ef = Ec
(b) Ec - Ef = 9kT
(c) Ec - Ef = 10kT
(d) Ef = Ec + kT
(e) Ec + Ef =
9kT
14. During heating a non-degenerate semiconductor material,……..……
(a) mass action law cannot be applied
(b) it is still at thermal equilibrium
(c) Charge neutrality equation cannot be applied
(d) it is at steady state
Problems
1.
Determine the total number of energy states in Si between Ec and Ec + 2kT at T = 300 K.
2.
Show that the probability of an energy state being occupied ΔE above the Fermi energy is the same as
the probability of a state being empty ΔE below the Fermi level.
3.
Calculate the energy range between fF(E) = 0.95 and fF(E) = 0.05 for (a) T = 300 K and (b) T = 500 K.
Comment on your results
4.
Estimate the temperature at which the intrinsic carrier concentration in Si is equal to the intrinsic carrier
concentration in Ge at room temperature.
5.
(a) The Fermi energy level for a particular material at T = 300 K is 5.50 eV. The electrons in this
material follow the Fermi–Dirac distribution function. (a) Find the probability of an electron occupying
energy at 5.80 eV. (b) Repeat part (a) if the temperature is increased to T = 700 K. (Assume that Ef is a
constant.) (c) Determine the temperature at which there is a 2% probability that a state 0.25 eV below
the Fermi level will be empty of an electron.
6.
(a) Calculate the temperature at which there is a 10-8 probability that an energy state 0.60 eV above the
Fermi energy level is occupied by an electron. (b) Repeat part (a) for a probability of 10-6.
7.
Determine the location of Fermi level with respect to the top of valence band in n-type germanium at
300 K, if the impurity content is one part in 106. There are 4.4×1028 atoms/m3 in Ge. Let Nc = 4.83x1021
T3/2, Eg = 0.72 eV and the difference between the bottom of the conduction band and the donor level is
0.01 eV .
8.
In a particular semiconductor material, the effective density of states functions are given by
Nc = Nco(T/300)3/2 and Nv = Nvo(T/300)3/2where Nco and Nvo are constants independent of temperature.
Experimentally determined intrinsic carrier concentrations are found to be ni = 1.4×102 cm-3 at T =
3
200 K and ni = 7.7×1010 cm-3 at T = 400 K. Determine the product Nco×Nvo and the bandgap energy
Eg. (Assume Eg is constant over this temperature range.)
9.
Assume the Boltzmann approximation in a semiconductor is valid. Determine the ratio of n(E) =
Nsc(E)f(E ) at E = Ec + 4 kT to that at E = Ec + kT/2.
10. (a) The carrier effective masses in a semiconductor are mn* = 1.21 mo and mp* = 0.70 mo. Determine
the position of the intrinsic Fermi level with respect to the center of the bandgap at T = 300 K. (b)
Repeat part (a) if mn* = 0.080 mo and mp* = 0.75 mo.
11. (a) The Fermi energy level in silicon at T = 300 K is 0.22 eV above the intrinsic Fermi level.
Determine n and p. (b) Repeat part (a) for GaAs.
12. A silicon semiconductor material at T = 300 K is doped with arsenic atoms to a concentration of
2×1015 cm-3 and with boron atoms to a concentration of 1.2×1015 cm-3. (a) Is the material n type or p
type? (b) Determine n and p. (c) Additional boron atoms are to be added such that the hole
concentration is 4×1015 cm-3. What concentration of boron atoms must be added and what is the new
value of n?
13. In silicon at T = 300 K, it is found that NA = 7×1015 cm-3 and p = 2×104 cm-3. (a) Is the material n
type or p type? (b) What are the majority and minority carrier concentrations? (c) What must be the
concentration of donor impurities?
14. Silicon at T = 300 K contains acceptor atoms at a concentration of NA = 5×1015 cm-3. Donor atoms are
added forming an n-type compensated semiconductor such that the Fermi level is 0.215 eV below the
conduction-band edge. What concentration of donor atoms is added?
15. (a) Silicon at T = 300 K is doped with donor impurity atoms at a concentration of ND = 6×1015 cm-3.
(i) Determine Ec - EF. (ii) Calculate the concentration of additional donor impurity atoms that must be
added to move the Fermi energy level a distance kT closer to the conduction band edge. (b) Repeat
part (a) for GaAs if the original donor impurity concentration is ND = 1×1015 cm-3.
16. (a) Determine the position of the Fermi energy level with respect to the intrinsic Fermi level in silicon
at T = 300 K that is doped with boron atoms at a concentration of NA = 2×1016 cm-3. (b) Repeat part
(a) if the silicon is doped with phosphorus atoms at a concentration of ND = 2×1016 cm-3. (c)
Calculate n and p in parts (a) and (b).
17. A new semiconductor material is to be “designed.” The semiconductor is to be p type and doped with
5×1015 cm-3 acceptor atoms. Assume complete ionization and assume ND = 0. The effective density
of states functions are Nc =1.2×1019 cm-3 and Nv = 1.8×1019 cm-3 at T = 300 K and vary as T 2. A
special semiconductor device fabricated with this material requires that the hole concentration be no
greater than 5.08×1015 cm-3 at T = 350 K. What is the minimum bandgap energy required in this new
material?
18. Silicon atoms, at a concentration of 7×1015 cm-3, are added to gallium arsenide. Assume that the
silicon atoms act as fully ionized dopant atoms and that 5% of the concentration added replace
gallium atoms and 95% replace arsenic atoms. Let T = 300 K. (a) Determine the donor and acceptor
concentrations. (b) Is the material n type or p type? (c) Calculate the electron and hole concentrations.
(d) Determine the position of the Fermi level with respect to Ei.
19. (a) The maximum intrinsic carrier concentration in a silicon device must be limited to 5×1011 cm-3.
Assume Eg =1.12 eV. Determine the maximum temperature allowed for the device. (b) Repeat part
(a) if the maximum intrinsic carrier concentration is limited to 5×1012 cm-3.
4