Blower Operation Manual
Standard operational guidelines for air blower systems.
1. Pre-Operation Checks
• Oil level: Check that the oil tank has enough lubricant to protect internal gears and bearings.
• Pipelines: Ensure all intake and exhaust pipes are tight and free of dust or debris.
• Valves: Open drain cocks or bypass valves so the motor does not start under a heavy load.
• Clearance: Clear the area around the unit to prevent safety hazards from vibration or moving parts.
2. Starting Procedure
• No-load start: Keep the drain cock or start valve open during initial ignition or power-up.
• Power activation: Flip the switch to the ON position for pull-start engines, or turn the key/press start for
electric models.
• Warm-up: Let the motor run for a brief moment without full resistance to stabilize internal temperatures and
pressure.
3. Running and Operation
• Load adjustment: Close the drain cock or open the main line valve gradually once the motor reaches stable
speed.
• Speed control: Operate the blower at the governed RPM or set the desired pressure/flow mode according to
your work needs.
• Monitoring: Watch for unusual noise, high vibration, or dropping airflow rates during continuous use.
4. Shutdown Procedure
• Reduce load: Decrease the speed or close primary discharge valves if required by your specific system.
• Power off: Flip the engine switch or turn the electric key to the OFF position.
• Cool down: Allow the unit to cool completely before performing any maintenance or cleaning.