MMDV212 – Test 3 – Bolts, Welding & Springs
October 2023
QUESTION 1 – Power Screw Design
(40 marks)
A square-thread power screw has a major diameter of 20 mm and a pitch of 3 mm with double
threads and transmits an axial load of 3 kN. A 30mm collar provides the bearing surface for the
reaction force. The friction coefficient of the threads and collar are f = fc = 0.08.
(a)
(b)
(c)
(d)
(e)
(f)
(g)
Find the thread depth, thread width, pitch diameter, minor diameter, and lead.
[5]
Find the torque required to raise and lower the load.
[12]
Find the efficiency during lifting the load.
[3]
Find the body stresses, torsional and compressive.
[6]
Find the bearing stress on the first thread.
[3]
Find the thread bending stress at the root of the first thread.
[3]
Determine the von Mises stress at the critical stress element where the root of the first
thread interfaces with the screw body.
[8]
QUESTION 2 – Mechanical Springs
(34 marks)
A helical compression spring is made of 1.5mm diameter music wire. The outside coil diameter of
the spring is 20mm. The ends are plain ground and there are 16 total coils.
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
Estimate the torsional yield strength of the wire.
[7]
Estimate the static load corresponding to the yield strength.
[7]
Estimate the stiffness of the spring.
[5]
Estimate the deflection that would be caused by the load in part (b).
[3]
Estimate the solid length of the spring.
[3]
What length should the spring be to ensure that when it is compressed solid and then
released, there will be no permanent change in the free length?
[3]
Given the length found in part ( f ), is buckling a possibility?
[3]
What is the pitch of the body coil?
[3]
Total = 74 marks