FACULTY OF ENGINEERING & BUILT ENVIRONMENT
Department of Industrial and Systems Engineering
PROJECT RUBRIC – T4
COURSE:
Diploma: Industrial Engineering
SUBJECT:
Engineering Manufacturing Technology – EMT150S
DUE DATE:
31 July 2026
TOTAL:
100 marks = 100%
STUDENT 1 SURNAME: ………………………………....…………..………………………………....………
STUDENT NUMBER: ………………………………....………
STUDENT 2 SURNAME: ………………………………....…………..………………………………....…
STUDENT NUMBER: ………………………………………
MARK OBTAINED ………………………………………..%...
SURNAME & STUDENT NUMBER: ………………………………....…………..………………………....…
SURNAME & STUDENT NUMBER: ………………………………....…………..………………………....…
COMPANY VISITED.…………………………………………………….………………………………………
PROVINCE .…………………………………………………….……………………………………………….
DATE OF VISIT…………….. ………….………….………….………….…………………………………….
CO. CONTACT PERSON ………………………………………………………………………………………
CONTACT NUMBER……………………………………………………………………………………………
MARKING RUBRIC FOR WRITTEN
PROJECT.
Cover page, contents page, page
numbering, acknowledgments, details
of company
Introduction (Sentence structure,
grammar, spelling & punctuation)
Project layout/presentation
Design process
Design considerations
Process flow diagram
Manufacturing processes
Machines & hand tools used
Material handling systems
Automation Technologies
Industry 4.0. approach
Costing procedure
Waste management
Work analysis - Safety
Conclusion, referencing,
recommendations
TOTAL
Below
Poor
Average
Above
Sufficient
average
Excellent
Score
Out of
1
2
3
4
5
5
1
2
3
4
5
5
1
2
3
4
5
5
2
4
6
8
10
10
1
2
3
4
5
5
1
2
3
4
5
5
3
5
9
12
15
15
1
2
3
4
5
5
1
2
3
4
5
5
1
2
3
4
5
5
1
2
3
4
5
5
1
2
3
4
5
5
1
2
3
4
5
5
2
4
6
8
10
10
2
4
6
8
10
10
100
ENGINEERING MANUFACTURING TECHNOLOGY: EMT150S
Graduate Attributes 5
Rev.: 03 - 2026
General
Exceeds
Expectat
ions
Meets
Expectations
Marginal
Below Expectations
Demonst
rates a
skilful
ability.
Demonstrates
ability.
Demonstrates
some ability.
Demonstrates minimal or
no ability.
ENGINEERING MANUFACTURING TECHNOLOGY
EMT150S
Graduate Attribute 5: Use of engineering tools
(Demonstrate competence to apply appropriate techniques, resources and modern computing,
engineering and IT tools to well-defined engineering problems, with an awareness of the limitations)
Rev.: 06 – 2026
SURNAME: …………………………………………………………………………………………..…........
STUDENT NUMBER: …………………..………………………………………………………………….…
2. The method, skill or tool is applied correctly.
- Automation and Industry 4.0 approach
- Design process and design considerations (tools)
3. Results produced by the method, skill or tool are tested and assessed
- Work analysis – investigation of injuries and finding solutions
4. Relevant computer applications are selected and used. Computer packages for
information handling and presentation. General flow of project
Student Meets Graduate Attribute (Yes or No):
Lecturer.
Signature: ………………............................................................................
Date: ……………………………...
Exceeds Expectations
Meets Expectations
Marginal
Below Expectations
1. Discipline-specific tools, processes or procedures noted in the project
- Manufacturing processes well explained with process flow