ENGINE SYSTEMS CLASSROOM
MANUAL CH.3 COOLING SYSTEMS
A crossflow radiator:
Select one:
a. Has a tank at either side of the core
b. Operates in the same way as a downflow radiator
c. Allows a lower car hood line
d. All of the above - CORRECT ANSWER -d. All of the above
A radiator cap contains:
Select one:
a. A pressure valve
b. A vacuum valve
c. Both a and b
d. Neither a nor b - CORRECT ANSWER -c. Both a and b
At low engine speeds, a variable-pitch fan blade is:
Select one:
a. Flattened
b. Sharply angled
c. Pulling less air
d. None of the above - CORRECT ANSWER -b. Sharply angled
Coolant recovery systems:
Select one:
a. Increase cooling system efficiency
b. Use pressure caps that don't vent to the atmosphere
c. Always maintain a full cooling system
d. All of the above - CORRECT ANSWER -d. All of the above
Cooling systems are pressurized to:
Select one:
a. Prevent the coolant from rusting the engine metal
b. Make water pump lubrication unnecessary
c. Raise the coolant's boiling point
d. None of the above - CORRECT ANSWER -c. Raise the coolant's boiling point
Late-model thermostats are operated by:
Select one:
a. A thermo-siphon
b. A wax pellet
c. A bimetal temperature sensor
d. Any of the above - CORRECT ANSWER -b. A wax pellet
Modern engines use a coolant that is:
Select one:
a. 100 percent water
b. About 50 percent water, 50 percent alcohol
c. About 20 percent water, 80 percent ethylene-glycol
d. None of the above - CORRECT ANSWER -d. None of the above
Radiator hoses can be:
Select one:
a. Molded in a specific shape
b. Ribbed, flexible lengths
c. Reinforced with a wire coil
d. Any of the above - CORRECT ANSWER -d. Any of the above
The curved chamber of a water pump is called the:
Select one:
a. Impeller
b. Pulley
c. Scroll
d. Any of the above - CORRECT ANSWER -c. Scroll
The radiator fan:
Select one:
a. Increases airflow at idle or low vehicle speeds
b. May waste engine power at high vehicle speeds
c. Both a and b
d. Neither a nor b - CORRECT ANSWER -c. Both a and b
The thermostat prevents:
Select one:
a. Cold coolant from entering the radiator
b. Hot coolant from entering the engine
c. Both a and b
d. Neither a nor b - CORRECT ANSWER -a. Cold coolant from entering the radiator
Water pumps must turn __________ to be efficient.
Select one:
a. Fast
b. Clockwise
c. Counterclockwise
d. None of the above - CORRECT ANSWER -a. Fast
When you work on an engine that has an electric radiator fan, you should __________ before you
get near the fan.
Select one:
a. Install a shroud
b. Disconnect the battery positive cable
c. Bring the engine to its normal operating temperature
d. Disconnect the battery ground cable - CORRECT ANSWER -d. Disconnect the battery ground cable
Which of the following is not part of the radiator?
Select one:
a. Tubes
b. Core plugs
c. Fins
d. Tanks - CORRECT ANSWER -b. Core plugs
__________ is stamped on the outside of a replacement thermostat.
Select one:
a. The engine displacement
b. "Wax"
c. The opening temperature
d. The direction of installation - CORRECT ANSWER -c. The opening temperature
About two-thirds of the heat energy from combustion is converted to mechanical energy.
Select one:
True
False - CORRECT ANSWER -False
Core, or freeze, plugs protect an engine from the damage which can occur if the coolant mixture
should freeze.
Select one:
True
False - CORRECT ANSWER -False
Each 1-psi (7-kPa) increase in cooling system pressure raises the coolant's boiling point by about 3
Deg. F (2 Deg. C).
Select one:
True
False - CORRECT ANSWER -True
Earlier engines tend to run colder than late model engines.
Select one:
True
False - CORRECT ANSWER -True
Electric radiator fans cannot run when the vehicle's ignition is off.
Select one:
True
False - CORRECT ANSWER -False
Flexible fan blades are designed to conserve engine power.
Select one:
True
False - CORRECT ANSWER -True
Having more than 50 percent ethylene-glycol in a coolant mixture will raise rather than lower the
freezing point.
Select one:
True
False - CORRECT ANSWER -False
Most engines use a liquid coolant to transfer heat from the atmosphere to the engine metal.
Select one:
True
False - CORRECT ANSWER -False
Other than flow direction there is no operational difference between downflow and crossflow
radiators.
Select one:
True
False - CORRECT ANSWER -True
The cooling system is pressurized to increase water pump efficiency and to raise the coolant's boiling
point.
Select one:
True
False - CORRECT ANSWER -True
The radiator cap vacuum valve allows atmospheric pressure to enter the system as the coolant cools.
Select one:
True
False - CORRECT ANSWER -True
The thermostat controls coolant circuilation between the water pump and the cylinder block.
Select one:
True
False - CORRECT ANSWER -False
The thermostat is mounted in the top or side of the radiator tank.
Select one:
True
False - CORRECT ANSWER -False
Wax-actuated thermostats do not operate reliably under varying cooling system pressures.
Select one:
True
False - CORRECT ANSWER -False
When a fluid drive fan is hot, there is very little silicone present in the drive.
Select one:
True
False - CORRECT ANSWER -False