Case Study 1: Material Selection for a Plate Heat Exchanger in a Chemical Process
Background
A chemical processing plant operates a plate heat exchanger to cool a hot aqueous acidic stream leaving a reactor
before downstream separation. The exchanger is compact, operates continuously, and must maintain high thermal
efficiency over long service times.
Problem
The heat exchanger plates must satisfy the following requirements:
Thermal performance
•
High thermal conductivity to enable efficient heat transfer.
Chemical resistance
•
Process fluid: aqueous organic acid solution (pH 2–3)
•
Cooling side: treated water
•
Material must resist uniform corrosion and localized attack.
Mechanical integrity
•
Operating pressure: up to 6 bar
•
Plates must withstand cyclic pressure and thermal stresses.
Temperature
•
Operating range: 20–90 °C
Fouling & cleanability
•
Must tolerate periodic cleaning using mild alkaline or acidic solutions.
Cost , manufacturability & sustainability
•
Suitable for industrial-scale production of thin plates
•
Reasonable material and fabrication cost
•
Prefer materials with long service life and recyclability, and avoid materials with hazardous byproducts or
manufacturing
Your Task
1.
2.
3.
4.
Translate application requirements into material property needs.
Identify at least three candidate materials for heat exchanger plates.
Select the best candidate and justify your choice.
Recommend a suitable manufacturing and forming process for the plates.
Deliverable (1–2 pages)
•
•
•
Property comparison table
Final material selection + justification
Processing/forming technique explanation
Later Extension – Failure & Mitigation Analysis
Propose one likely failure mode for your selected material and one mitigation strategy.