1.
The inside diameter of bearings used in an aircraft landing gear assembly are known to have a
standard deviation of σ=0.002 cm. A random sample of 15 bearings has an average inside diameter
of 8.2535 cm.
1.1 Test the hypothesis that the mean inside bearing diameter is 8.25 cm. Use a two-sided
alternative and 𝛼 = 0.05.
1.2 Find the P-value for this test.
1.3 Construct a 95% two-sided confidence interval on the mean bearing diameter.
2.
The service life of a battery used in a cardiac pacemaker is assumed to be normally distributed. A
random sample of ten batteries is subjected to an accelerated life test by running them continuously
at an elevated temperature until failure, and the following lifetimes (in hours) are obtained: 25.5,
26.1, 26.8, 23.2, 24.2, 28.4, 25.0, 27.8, 27.3, and 25.7.
2.1 The manufacturer wants to be certain that the mean battery life exceeds 25 hours. What
conclusions can be drawn from this data? (Use α=0.05)
2.2 Construct a 90% two-sided confidence interval on mean life in the accelerated test.
3.
A random sample of 200 printed circuit boards contains 15 defective or nonconforming units.
Estimate the process fraction nonconforming.
3.1 Test the hypothesis that the true fraction nonconforming in this process is 0.10.
(Use α=0.05)
4.
An experiment was conducted to investigate the filling capability of packaging equipment at a
winery in Newberg, Oregon. Twenty bottles of Pinot Gris were randomly selected and the fill volume
(in ml) measured. Assume that fill volume has a normal distribution.
The data are as follows:
753, 751, 752, 753, 753, 753, 752, 753, 754, 754, 752, 751, 752, 750, 753, 755, 753, 756, 751, 750.
4.1 Do the data support the claim that the standard deviation of fill volume is less than 1 ml?
(Use α=0.05)
5.
Suppose that you are testing the following hypotheses where the variance is known:
5.1 Find the P-value for the following values of the test statistic Z0 = -2.05