with BIRD ON and A/THR ON
INTRODUCTION
• Preparation of initial approach
• Preparation for intermediate and final approach
• Sequence of visual pattern
Prepared by: Krešimir Puch
INITIAL APPROACH
The crew must keep in mind that the pattern is flown visually. However, the XTK and PROG
page are a good cue of the aircraft lateral position versus the runway threshold and
centreline.
The crew will try to get the following configuration on commencement of the downwind leg:
•
BIRD ON
•
The downwind track will be selected on the FCU to assist in downwind tracking
•
A/THR confirmed active in speed mode, i.e. SPEED on the FMA
•
Managed speed will be used to enable the "GS mini” function
•
Set Go-Around altitude on the FCU
•
PROG page selected (both pilots)
•
Both AP and FDs will be selected off
Prepared by: Krešimir Puch
INTERMEDIATE / FINAL APPROACH
•
Assuming a 1500 ft AAL circuit, the base turn should be commenced 45 sec
(3 sec per 100 ft) after passing abeam the downwind threshold
(±1 s/kt head/tailwind).
•
Insert the active R/W in the PROG page to identify accurately when passing abeam the
active R/W threshold ( 90º to R/W threshold)
•
The final turn onto the runway centreline will be commenced with 25° angle of bank.
•
Initially the rate of descent should be 200-300 ft/min, increasing to 700 ft/min when
established on the correct descent path
•
The pilot will aim to be configured for landing at VAPP by 500 ft AAL, at the latest.
•
If not stabilised, a go-around must be carried out.
Prepared by: Krešimir Puch
Prepared by: Krešimir Puch
APPROACHING
DOWNWIND
•
Activate Approach Phase
•
Check Speed Managed
•
FPV (Bird) ON
•
Readjust TRK (down wind)
•
Set Go-Around Altitude
•
AP & F/D Off
•
Check R/W positioning (ROSE-NAV 10
NM, MIN 2.5NM from R/W Axis)
•
Select PROG page and insert landing R/W
Prepared by: Krešimir Puch
ENTERING DOWNWIND
•
•
•
•
LEVEL –OFF ( 1500 ft AAL)
Green dot speed Flap One
Abeam Threshold – Start Time –
(3sec / 100ft ) ± 1sec/1kt of
wind
Before turning to base leg
(Flaps 2)
F2
F1
Timing 45 sec-1500ft
Check 90º
to the
R/W
threshold
Prepared by: Krešimir Puch
TURNING BASE
•
•
•
•
40 sec - PF call - Set TRK XXX (base leg TRK)
45 sec- Set FLAP 2, start turning and initiate a shallow descent (200-300 fpm) to reach the profile
Gear Down
FLAP 3
Set base leg track using the 90º marking
L/G down
F3
Level the wing and check your
position relative to the R/W
(90º check)
Prepared by: Krešimir Puch
TURNING FINAL
•
•
•
•
When Turning Final
PF call – Set R/W TRK
Flaps FULL
Increase rate of descent to about
700 FPM
Aircraft to be stabilized before
reaching 500ft AGL (VMC)
About 1000ft
At 500ft A/C Stabilized
at VAPP
FULL
Prepared by: Krešimir Puch
CONCLUSION
• Flight pattern saves fuel, flight time
• Improves pilot’s flying skills
Prepared by: Krešimir Puch