Author: brian.leeper@gmail.com
December 2025
Note: I did my own testing with the actual hardware to determine this pinout. This
is not something I just copied out of a service manual.
I used VHDCI 50 and MDR 50 breakouts to verify the cable wiring. I disassembled the
HB-3 headbox to identify the function of pins that do
not connect to touchproof jacks on the HB-3. I spent some time on this. If you wish
to use this pinout in your own work, all that I ask is that you
attribute it to me, brian.leeper@gmail.com
Nicolet v32/v44 and Somnostar z4 headbox cable pinout.
HB-3 cable pin out; same pinout on both ends of cable. VHDCI 50 at amplifier end;
VHDCI 50 at v44 HB-3 end; MDR 50 at Z4 HB-3 end
todo: Identify power and data pins used with HB-4 headbox (has impedance display
LEDs and controls for impedance test). Probably pin 49
and the R1/R2/R3 and resistor ID common are used for these functions. HB-4 headbox
works correctly with a straight thru wired cable.
Somnostar z4 does not work with the impedance checking functions of the HB-4.
Nicolet v44 works fine, as expected. I do not have a
Nicolet v32 to test with the HB-4.
1 F4/4
2 323 F7/11
4 315 28+
6 307 Pz/21
8 269 A1/17
10 T6/16
11 ROC/22
12 25+
13 LOC/23
14 25 15 24 +
16 T5/15
17 A2/18
18 27+
19 RESISTOR ID COMMON (R1/R2/R3)
20 T4/14
21 TP1 (test point 1)
22 2723 GND
24 T3/13
25 GND
26 FP2/2
27 R2 (1K populated on v44 HB-3 and Z4 HB-3) -- this resistor seems not to matter
for headbox disconnect detection. not used?
28 FP1/11
29 F3/3
30 C3/5
31 32+
32 C4/6
33 31+
34 P3/7
35 Cz/20
36 P4/8
37 26+
38 F8/12
39 Fz/19
40 2841 2442 O1/9
43 R1 (1K populated on v44 HB-3; empty on Z4 HB-3) -- this resistor MUST be
populated for it to re-detect the headbox after a disconnection.
44 O2/10
45 REF
46 29+
47 R3 (1K populated on v44 HB-3 and Z4 HB-3) -48 2949
50 30+