Problems One-Dimensional Compressible Flow
1. Consider the isentropic supersonic flow through a convergent-divergent nozzle with an
exit-to-throat area ratio of 10.25. The reservoir pressure and temperature are 5.06625bar
and 333.3K, respectively. Calculate M, p, and T at the nozzle exit.
2. Consider the isentropic flow through a convergent-divergent nozzle with an exit-tothroat area ratio of 2. The reservoir pressure and temperature are 1.01325bar and 288
K, respectively. Calculate the Mach number, pressure, and temperature at both the
throat and the exit for the cases where (a) the flow is supersonic at the exit and (b) the
flow is subsonic throughout the entire nozzle except at the throat, where M = 1.
3. The reservoir pressure and temperature for a convergent-divergent nozzle are
5.06625bar and 289K, respectively. The flow is expanded isentropically to supersonic
speed at the nozzle exit. If the exit-to-throat area ratio is 2.193, calculate the Mach
number, pressure and temperature at the exit.
4. A flow is isentropically expanded to supersonic speeds in a convergent-divergent
nozzle. The reservoir and exit pressures are 1.01325 and 0.3185 bar atm. What is the
value of π΄ ⁄π΄∗ ?
5. A convergent-divergent nozzle with an exit-to-throat area ratio of 1.616 has exit and
reservoir pressures equal to 0.917 and 1.01325 bar, respectively. Assuming isentropic
flow through the nozzle, calculate the Mach number and pressure at the throat.
6. For the flow in Problem 5, calculate the mass flow through the nozzle, assuming that
the reservoir temperature is 288 K and the throat area is 0.3 m2.
7. Repeat problem 5 with exit and reservoir pressures of 0.134 and 1.01325 bar.
8. A convergent-divergent nozzle with an exit-to-throat area ratio of 1.616 has exit and
reservoir pressures equal to 0.6 and 1.01325 bar, respectively. Determine the stagnation
pressure at the exit and increase of entropy in the nozzle.
9. A pressurized tank that contains air with at a stagnation temperature of π = 293.15K
discharges to the atmosphere (π = 1.01325bar) through a convergent-divergent
nozzle with an area ratio of 2.5 where π΄ is the area of the exit section and π΄ is the
area of the throat.
a) Determine the range of tank stagnation pressures π and exit Mach number π for
which the flow in the nozzle is isentropic.
b) Determine the stagnation pressure π in the tank that leads to largest stagnation
pressure loss in the nozzle.
10. A pressurized tank contains air with at a stagnation pressure of π = 293.15K and
stagnation pressure π = 10bar discharges to the atmosphere (π = 1.01325bar)
through a convergent-divergent nozzle.
a) Determine the range of area ratios π΄ ⁄π΄ where π΄ is the area of the exit section
and π΄ is the area of the throat for which the flow in the nozzle is isentropic.
b) Determine the loss of stagnation pressure π in the nozzle when π΄ ⁄π΄ = 3.
11.The figure below presents the pressure π and the Mach number ππ along
of a convergent-divergent nozzle that has a stagnation pressure π at the
inlet and an outlet pressure equal to π . Assume that the flow is adiabatic
and uni-dimensional and that viscous effects are negligible.
1
a
2
4
3
Line 3 corresponds to exit pressures in the range π ≤ π ≤ π .
The inlet and exit stagnation pressures are equal for the range of exit
pressures π < π < π .
If the ratio between the exit and throat areas increases, the difference
between ππ and ππ grows.
For π ≤ π , line 1 represents the evolution of the Mach number in the
nozzle.
12.The figure below presents the pressure π along of a convergent nozzle that
has a stagnation pressure π at the inlet and an external pressure equal to
π . Assume that the flow is adiabatic and uni-dimensional and that viscous
effects are negligible.
The flow rate for exit pressures 3 and 4 is identical.
The flow in the nozzle (including the exit) is always subsonic (ππ < 1).
The value of π∗ ⁄π does not depend on π .
The exit pressure π is always equal to the external pressure π .