ENGINEERING 2430
EXPERIMENT #3
TRIAC LAMP
DIMMER
OBJECTIVE:
To study an application of the triac as a light dimmer.
THEORY:
The triac makes a good light dimmer control, as explained in the GE SCR Handbook 6TH
edition.. A single-RC charging circuit will work, but the dual RC charging circuit shown in
figure 1 gives smoother control.
Unlike an SCR, which will conduct only in one direction (as a diode does), a triac will
conduct in both directions (polarities) of the input sine wave giving a full 360 degrees of phase
control.
EQUIPMENT:
Oscilloscope
Digital multimeter with true RMS AC voltmeter
115V:115V isolation transformer
115V 150W lamp and socket
X100 attenuator box
GE ST-2 diac
2N6343 400V 6A triac
Sunglasses
20
SCHEMATIC DIAGRAMS:
Figure 1
PROCEDURE:
Photographs of the waveforms are permitted instead of sketching them. However,
take good quality pictures, i.e. camera square on to screen, no reflections, properly
focused and printed in ½ page size. Clearly indicate what the photograph is of, indicate
which waveform is which. Waveforms may also be saved on a USB thumb drive.
1) Connect the circuit of figure 1. Check that the 250K potentiometer actually does
control light intensity.
2) Adjust the 100K potentiometer so that the 250K pot will give full range control
-on
3)
For each of five pot settings between minimum and maximum, measure and record the
following:
i) VS (RMS) (with an ac voltmeter)
ii) IL (true RMS) measure with an ac voltmeter across the 1 ohm sampling resistor
and divide by 1 to get amps.
iii) Accurately scaled sketch of VL (using X100 attenuator)
iv) Accurately scaled sketch of VA (using X100 attenuator)..CH2
v) Accurately scaled sketch of VX (using X100 attenuator)
vi) A visual estimation of light intensity
vii) Total resistance of RAX (make sure POWER IS REMOVED from circuit
BEFORE making this measurement)
viii) Firing angle
21
NOTE: All the above sketches of waveforms are made with reference to
VS for proper time relationships.
VS cannot be measured directly because of the location of the
circuit ground, so you must visualize the proper phase relationship
so that your sketches will indicate the proper phasing.
RESULTS:
Photographs of the waveforms are permitted instead of sketching them. However, take
good quality pictures, i.e. camera square on to screen, no reflections, properly focused
and printed in ½ page size. Clearly indicate what the photograph is of, indicate which
waveform is which.
1) A detailed explanation of how the circuit works.
2) A plot of IL vs RAX .
3) A plot of firing angle vs RAX .
4) Sketches of all waveforms placed one under the other to show proper timing
5) A plot of light intensity vs RAX . Does it match the curve in 2) If not, why not?
6) All waveforms to be properly labeled and scaled properly.
7) Any questions raised in the various steps of the experiment should be answered with
unambiguous indication of which answer pertains to which question. The brief answers
must include your reasoning ( support your answer ).
8) Conclusions ( clearly stated ).
22