ELECTRICAL CIRCUITS
KIRCHHOFF’S LAWS
1
Kirchhoff’s laws
(a) Current Law.
At any junction in an electric circuit the total
current flowing towards that junction is equal
to the total current flowing away from the
junction, i.e. ΣI = 0
2
(b) Voltage Law.
In any closed loop in a network, the algebraic
sum of the voltage drops (i.e. products of
current and resistance) taken around the loop
is equal to the resultant e.m.f. acting in that
loop.
3
Find the unknown currents marked in Figure (a)
4
•
5
Determine the value of e.m.f. E in Fig.(b).
6
Applying Kirchhoff’s voltage law and
moving clockwise around the loop
7
m
• Determine vo and i in the circuit shown in
Fig
8
NET WORK ANALYSIS USING
KIRCHHOFF’S LAWS
Use Kirchhoff’s laws to determine the
currents flowing in each branch of the
network
shown
•
9
10
Third Loop used as a check
11
Solution of simultaneous equations
using determinants
• When Kirchhoff’s laws are applied to electrical
circuits, simultaneous equations result which require
solution. If two loops are involved, two simultaneous
equations containing two unknowns need to be solved;
if three loops are involved, three simultaneous
equations containing three unknowns need to be
solved and so on. The elimination and substitution
• methods of solving simultaneous equations may be
used to solve such equations. However a more
convenient method is to use determinants.
12
Matrix and Determinants – Two Unknowns
13
14
Determine the currents flowing in the following
network using the following methods:
a) Substitution
b) Matrix and determinants
•
15
a) Using substitution
•
16
continuation
17
b)
Using matrix and determinants
•
18
Three unknowns - Determinants
19
Continuation
20
To evaluate a 3 × 3 determinant:
21
•
22
•
23
a)
Determine the current flowing in the 2 Ω
resistor of the circuit shown using Kirchhoff’s laws.
b)
Find the power dissipated in the 3 Ω resistance.
•
24
Assigned currents and their directions
25
Three loops
26
Using determinants
•
27
•
28
29
Wye-Delta Transformations
• Situations often arise in circuit analysis when the resistors are
neither in parallel nor in series. For example, consider the bridge
circuit
• How do we combine resistors through when the resistors are neither
in series nor in parallel?
• Many circuits of this type can be simplified by using three-terminal
equivalent networks.
30
Wye-Delta Transformations
• These are the wye (Y) or tee (T) and the delta or pi
network
31
Wye-Delta Transformations
• These networks occur by themselves or as part of a
larger network.
• They are used in three-phase networks,electrical filters,
and matching networks.
• Our main interest here is in how to identify them when
they occur as part of a network and how to apply wyedelta transformation in the analysis of that network
32
Delta to Wye Conversion
33
THE END
34