6.8.2023
Calculating weld strength
6.8.2023
Assumptions:
• Isotropic material (same material properties in all directions)
• Static load
• Elastic method - Assumes the stress in the weld is linear to its
deformation (the weld material stays in its elastic zone), so shear stresses
and stresses due to torsion/bending can be summed up (superposition).
6.8.2023
Step 1 – Shear stress at a given point:
ππ =
π·
π¨ππππ
=
π·
0.707β β πΏπ€πππ
(src:)
Where:
ππ – Stress due to shearing force [Pa]
π – Shearing force (vertical load on beam/welded part) [N]
π΄π€πππ – Weld area [m2]
β - Weld size [m]
πΏπ€ππππ – Total length of welds [m]
6.8.2023
Step 2.0 - Stress due to torsion at a given point:
π΄πππ β π
ππ» =
π±π
Where:
ππ» - Stress due to torsion at a given point in the weld [Pa]
π΄πππ – Maximum torque (assumed to be acting on the geometric center of the weld path) [Nm]
π – Distance between given point in the weld and geometric center of the weld path [m]
π±π – Polar moment of inertia of the weld path [m4]
6.8.2023
Step 2.1 – Calculating ππππ₯ :
- Choose the theoretical model which best describes your
application:
https://awc.org/wp-content/uploads/2021/12/AWC-DA6BeamFormulas-0710.pdf
- Calculate ππππ₯ according to the formula given in the
model.
(Calculating/estimating a value for a distributed load may
be needed).
6.8.2023
Step 2.2 – Choosing point and calculating the distance π:
To be on the safe side, several points at the edges of the weld
should be examined, but usually the most “dangerous” point
will be the one furthest from the geometric center.
In the following example, the size of the reaction stress vector
due to torque
is maximized and the reaction shear-stress
vector adds to it rather than reducing from it. Thus, the
resulting combined reaction stress vector is greatest at this
point.
6.8.2023
Step 2.3 - Calculating π±π :
π±π = 0.707βπ½π’
Where:
β - The weld size [m]
(src: 'Shigley's Mechanical Engineering Design', page 476, Table 9–1)
6.8.2023
Step 2.4 – Calculating size and direction of ππ» :
The formula in step 2.0 calculates the size of the reaction stress
vector due to torque . Its direction is perpendicular to the
line connecting the point chosen and the geometric center of
the weld path.
Step 2.5 – Break ππ» into its x,y components:
6.8.2023
Step 2.6 – Sum-up x components and y components of both ππ and ππ» to
get the total stress vector:
Step 2.7 – Calculate the size of the Total Stress Vector (Using Pythagoras)
6.8.2023
Step 3 – choose an electrode material strength (yield/UTS) and calculate the ‘Permissible Stress’:
Pay attention to which strength the Type of Loading refers to (yield/UTS).
Step 4 – The size of the total stress vector (calculated in step 2.7) must be lower
than the Permissible Stress (calculated in step 3).