Computer Networks – Experiment 1
Name – Abhinav Jeansha
Batch – 3
Roll Number – 2024BEC0030
Ex.1: Establish a connection between two devices through Copper Crossover wire
Aim - To establish a connection between two devices through Copper Crossover wire using Cisco
packet tracer
Requirements1) Cisco Packet Tracer 8.2.1
2) Windows PC or 2 Linux PC, Each PC must Have One NIC cards
3) RJ-45 Sockets – Copper Cross-over Wire.
4) Class C IP Address using Static IP configuration
Physical Diagram –
Procedure –
1. Open the CISCO PACKET TRACER software.
2. Use two PC from the End Device Icons. (Change Names PC0 to PC-A, PC1 to PC-B)
3. Make the Connections using Copper Cross-over Ethernet Cable.
4. Enter the IP Address to each machine.
•
•
•
•
4.1 Double click the device
4.2 Select Config → INTERFACE → FastEthernet0 →IP Configuration → Click Static
4.3 Enter the IP address in the IPv4 Address. IPv4 Address: 192.168.1.1 4.5
Repeat 4.3 and 4.4 (Set unique IP address for other devices like 192.168.1.2,
192.168.1.3,......)
5. To verify the connection between PC-A to PC-B, the following steps are required.
•
•
5.1 Double click the device icon (PC-A) →Desktop→Command Prompt/Terminal
5.2 Enter C:/> ping 192.168.1.2 Where 192.168.1.2 is the IP address of PC-B.
6. Check the IP address for Every PC using ipconfig or ifconfig Command.
7. Check the connections using Ping Commands.
8. To know the MAC address of neighbouring PC do the following.
•
Double Click Device Icon (PC-B) → Desktop→ Command Prompt/Terminal