RECOMMENDED PRACTICE PROBLEMS
Problems:
• 22-30
22-30.
• 22-31
• 22-37
• 23-20
• 23-24
• 23-52
The figure below shows two concentric rings, of radii R and R′ = 3.00R, that lie on the same plane.
Point P lies on the central z axis, at distance D = 2.00R from the center of the rings. The smaller ring
has uniformly distributed charge +Q. In terms of Q, what is the uniformly distributed charge on the
larger ring if the net electric field at P is zero?
Recall that the electric field along the z-axis due to a ring of charge is
E=
qz
4πϵ0 (z 2 + R2 )3/2
where q is total charge on the ring and R is the radius.
22-31.
In the figure below, a non-conducting rod of length L = 8.15 cm has a charge of −q = −4.23 fC uniformly
distributed along its length. (a) What is the linear charge density of the rod? What are the (b) magnitude and
(c) direction (relative to the positive direction of the x axis) of the electric field produced at point P , at a
distance a = 12.0 cm from the rod? What is the electric field magnitude produced at distance a = 50 m by (d)
the rod and (e) a particle of charge −q = −4.23 fC that we use to replace the rod? (At that distance, the rod
”looks” like a particle.)
22-37.
Suppose you design an apparatus in which a uniformly charge disk of radius R is to produce an electric field. The
field magnitude is most important along the central perpendicular axis of the disk, at a point P at a distance
2.00R from the disk (shown in figure (a) below). Cost analysis suggests that you switch to a ring of the same
outer radius R but with inner radius R/2.00 (figure (b)). Assume that the ring will have the same surface charge
density as the original disk. if you switch to the ring, by what percentage will you decrease the electric field
magnitude at P ?
Hint: Use superposition together with the fact that the magnitude of the electric field produced by a flat, circular,
charged disk with radius R, surface charge density σ, and measured a distance d away from the disk along its
central axis, is given by:
σ
d
Edisk (d) =
1− √
2ϵ0
d2 + R 2
23-20.
A charged particle is held at the center of two concentric conducting spherical shells. Figure a) below shows a
cross section. Figure b) gives the net flux Φ through a Gaussian sphere centered on the particle, as a function of
the radius r of the sphere. The scale of the vertical axis is set by Φs = 5.0 × 105 N· m2 /C.
a) What is the charge of the central particle?
b) What is the net charge of shell A?
c) What is the net charge of shell B?
23-24.
The following figure shows a section of a long, thin-walled metal tube of radius R = 3.00cm, with a charge per
unit length of λ = 2.00 × 10−8 C/m. What is the magnitude E of the electric field at radial distance (a)
r = R/2.00 and (b) r = 2.00R? (c) Graph E versus r for the range r = 0 to 2.00R.
23-52.
The figure below shows a spherical shell with uniform volume charge density ρ = 1.84nC/m3 , inner radius
a = 10.0cm, and outer radius b = 2.00a. What is the magnitude of the electric field at radial distances (a) r = 0,
(b) r = a/2.00, (c) r = a, (d) r = 1.50a, (e) r = b, (f) r = 3.00b?
Numerical Solutions
22-30: −4.19Q
22-31: (a) −5.19 × 10−14 C/m (b) 1.57 × 10−3 N/C (d) 1.52 × 10−8 N/C (e) 1.52 × 10−8 N/C
22-37: 28.3%
23-20: (a) −8.0µC (b) +12µC (c) −5.3µC
23-24: (a) 0 N/C (b) 5990 N/C
23-52: (a) 0 N/C (b) 0 N/C (c) 0 N/C (d) 7.32 N/C (e) 12.1 N/C (f) 1.35 N/C