ME-400 Engineering Thermodynamics
Homework-4
(Due Date- 4th October 2024, Friday)
1. An ideal Brayton cycle uses air as the working fluid. Air goes into the compressor at 100 kPa
and 300 K. The compressor pressure ratio is 7.5. The heat input to the combustion chamber is
1325 kJ/kg. Determine:
a) The temperature of the air going into the turbine (K) 1680
b) The work being made by turbine (kJ/kg) 773
c) The work being consumed by compressor (kJ/kg) 234
d) The thermal efficiency (%) 40.7
2. An ideal Brayton cycle uses air as the working fluid. The inlet volumetric flowrate is 2 m3/s.
Air goes into the compressor at 100 kPa and 300 K. The compressor pressure ratio is 9. The
temperature of the air going into the turbine is 1300 K. Determine:
a) The thermal efficiency (%)
b) The back work ratio (%)
c) The net power developed (kW)
d) If this was not an ideal cycle, would the back work ratio increase, decrease, or remain the
same and why?
3. Redo parts a-c of the problem directly above but the turbine and compressor each have an
isentropic efficiency of 80%.
4. An ideal Brayton cycle uses air as the working fluid. Air flowing at 6 kg/s goes into the
compressor at 100 kPa and 300 K. The compressor pressure ratio is 9. The air then goes
through a regenerator where it gains heat from the air leaving the turbine and from there it
goes to the combustor and then the turbine. The effectiveness of the regenerator is 80%. The
temperature of the air going into the turbine is 1300 K. Determine:
a) The thermal efficiency (%) 54.9
b) The back work ratio (%) 41.6
c) The net power developed (kW) 2215
d) How does this back work ratio compare to that in Questions 2 and 3?
e) How does the efficiency compare to that in Questions 2 and 3?
5. Air goes into a compressor of a Brayton cycle with a volumetric flow rate of 55 m3/s at 0.85
bar and 280 K. The pressure ratio across the compressor is 19. The isentropic efficiency of
the compressor is 94%. The air then goes through the regenerator which has an effectiveness
of 88%. The maximum temperature in the cycle is 2100 K. The air then goes through the
turbine which has an isentropic efficiency of 94% and the exhaust of the turbine flows through
the other side of the regenerator. Determine:
a) The net power developed (KJ/s)
b) The temperature of the air entering the turbine (K)
c) The thermal efficiency (%)