Higher Certificate in Mechanical Engineering & Electrical Engineering (NQF 5)
(ENGR 101)
Assessment
Test 2_Closed book Test
Intake
2-2025
Assessor
Payos Njini
Moderator
Adebola Adeyami
Total Marks
50 Marks
Contribution to Semester Mark
(weighting)
20%
Open Date
17 September 2025
Due Date
17 September 2025
Section A
Questions 1
25 Marks
Section B
Questions 2
25 Marks
Instructions to Student:
Submission:
o
o
o
o
o
You must answer all sections and questions.
Include your name, surname and student number on the assessment. Failure to do so will result in your
assessment not being marked.
Once completed, the document must be converted to PDF and uploaded to the student portal. If additional
information and/or documents should be included, upload them as a single Zipped folder.
You may use the subject learner guide, or prescribed textbook to assist you during the assessment.
You only get one submission opportunity for this assessment.
Plagiarism:
By submitting your assessment, you declare that you are familiar with AIE’s policy on plagiarism and are subject to a
penalty and/or disciplinary procedure if found guilty.
Submission issues:
No late submissions will be accepted. If you encounter any difficulty with the student portal, immediately take a
screenshot, log a ticket and attach the screenshot and your assessment to the ticket.
Page 1 of 4
Engineering Graphics (ENGR102)
Declaration:
I/we declare that all the information included in this assignment is my/our original work, apart from
where source material has been acknowledged. I/we acknowledge that I/we am/are aware of AIE’s
Plagiarism Policy and understand the consequences of breaching this policy – as well as any other AIE
policy relevant to me/us.
Student Name
Student Number
Student Signature
Date
Mark and Comments
Final Mark
_____%
Lecturer Comments
Page 2 of 4
Section A
QUESTION 1: ISOMETRIC DRAWING
Figure 1 shows TWO primary views of a component in first angle-orthographic projection.
Draw in scale 1:1, an isometric view of the model.
Point P must be the lowest point on your drawing.
NOTE: No hidden detail is required.
FIGURE 1
SUB TOTAL: [25]
Page 3 of 4
Section B
QUESTION 2: SECTIONAL DRAWING
Figure 2 below shows two primary views of a component.
Draw, to scale 1:1, and in first-angle orthographic projection, the following views of the
component:
2.1
A full-sectional front view
(8)
2.2
2.3
A left view
A full-sectional top view on cutting plane X-X
(8)
(9)
Show hidden detail in the left view only.
No dimensions required.
20
For the correct submission of one continuous pdf document.
5
[25]
TOTAL: 50 MARKS
Page 4 of 4