Mach 1 Rear Splash Guards Install
Instructions
NOTE: HOLES MARKED ON INSTALL PHOTOS WILL CORRESPOND WITH
SHOWN HOLES ON EXAMPLE SPLASH GUARD
GP(GUIDE
PIN)
HOLE 1
HOLE 2
HOLE 3
HOLE 4
HOLE 5
Hardware Summary:
*Holes 1 and 2 use supplied u-nuts and screws*
*Holes 3 and 4 reuse factory installed screws*
*Hole 5 uses supplied plastic push pin*
1. Lift vehicle and remove rear wheels
2. Remove 3 factory fender liner push pins and set aside, pull back fender
liner
3. Remove the two factory installed screws in holes 3 and 4 and set aside as
they will be reused
Hol
e1
Hol
e
2
Hol
e3
Hol
e4
4. Install included u-nuts onto holes 1 and 2
GP
Hole
Hole 1
Hole 2
Hole 3
Hole 4
NOTE: FOR REFERENCE HOLE 5 LOCATION (WHERE SUPPLIED PLASTIC PUSH
PIN WILL BE INSTALLED) SHOWN IN IMAGE BELOW IN RELATION TO
PREVIOUSLY IDENTIFIED HOLES
Hole 2
Hole 3
Hole 4
Hole 5
5. Install rear splash guard onto vehicle
*HOLES 1 AND 2 USE SUPPLIED SCREWS*
*HOLES 3 AND 4 USE REMOVED FACTORY INSTALLED SCREWS*
*HOLE 5 USES SUPPLIED PUSH PIN*
Once installed everything should look as shown
Guide Pin
Hole 1
Hole 2
Hole 3
Hole 4
Hole 5
6. Put fender liner back into position and reinstall 3 factory push pins
7. Reinstall wheels and lower vehicle
Repeat on both sides of vehicle