1
The cells, lamps and resistors in the circuits are identical. In
which circuit is the lamp the brightest?
A
B
C
D
2 Which component, when used in a circuit, allows current to pass in only one direction?
A
B
C
D
3
A potential divider consists of a thermistor and a light-dependent resistor (LDR).
6.0 V
V
0V
Which conditions give the smallest voltage V across the LDR?
A
cold and dark
B
cold and light
C
hot and dark
D
hot and light
4 Which diagram shows the arrangement of the ammeter and voltmeter to obtain readings to find
the power of a lamp?
B
A
V
V
A
C
A
D
V
A
A
V
5 A 6.0 V battery is connected to a network containing five identical resistors. A voltmeter has one
lead connected to point K as shown.
At which point should lead L be connected so that the voltmeter reads 3.0 V?
6.0 V
A
B
D
C
K
L
V
6 A split-ring commutator is used in a simple d.c. motor. It reverses the current in the coil.
How often does it reverse the current?
7
A
every quarter turn
B
every half turn
C
every full turn
D
every two turns
The diagram shows a simple d.c. motor.
N
S
The switch is closed and the coil rotates.
Which change makes the coil rotate in the opposite direction AND at a faster rate?
8
A
increase the current in the coil and increase the number of turns in the coil
B
reverse both the magnetic field and the current in the coil
C
reverse the magnetic field and decrease the current in the coil
D
reverse the magnetic field and increase the current in the coil
The diagram shows a wire PQ between the N-pole and the S-pole of a magnet. There is a current
in the wire in the direction of the arrow.
N
P
Q
S
What is the direction of the force on the wire PQ?
A
into the page
B
out of the page
C
towards the N-pole
D
towards the S-pole
9 A teacher moves a magnet into and out of a coil of wire, as shown, in order to demonstrate electromagnetic
induction.
direction of
movement
of magnet
S
coil
N
magnet
V
Which statement is correct?
10
A
As the magnet is moved into the coil the left-hand end of the coil becomes a S-pole.
B
As the magnet is taken out of the coil the left-hand end of the coil becomes a N-pole.
C
Increasing the speed at which the magnet enters the coil, increases the induced voltage.
D
Increasing the speed at which the magnet leaves the coil decreases the induced voltage.
A magnet is placed near to a solenoid that is connected to a sensitive centre-zero ammeter. solenoid
magnet
A
sensitive ammeter
The magnet is pushed towards the solenoid. It accelerates, then moves at constant speed, then decelerates
and stops inside the solenoid.
When is the reading on the ammeter zero?
A
when the magnet is accelerating
B
when the magnet is moving at constant speed
C
when the magnet is decelerating
D
when the magnet is stationary
11 Four plotting compasses are placed near a bar magnet. You may ignore any effects of the Earth’s
magnetic field.
One compass appears like this
.
What is a possible position for this compass?
A
S
B
N
C
D
12
A metal bar PQ hangs from a thin thread and always comes to rest with end P pointing north.
Another bar XY of the same metal settles in no definite direction.
What happens if the two bars are brought near one another?
A
End P and end Q both attract end X.
B
End P attracts end X but repels end Y.
C
End P neither attracts nor repels end X.
D
End P repels end X but attracts end Y.
13 The diagram shows a 12 V d.c. power supply connected across a coil with a metal core.
metal core
12 V d.c.
power supply
coil of wire
The core becomes a magnet when the current is switched on. It remains a magnet after the
current is switched off.
From which metal is the core made?
A
aluminium
B
copper
C
soft iron
D
steel
14 The diagrams show a small compass close to a strong bar magnet.
Which diagram shows the correct compass direction?
A
B
C
D
S
S
S
S
N
N
N
N
15 The magnetic field around two bar magnets is shown.
Which diagram represents the correct arrangement of magnetic poles?
A
N
S
N
S
B
N
S
S
N
C
S
N
N
S
D
S
N
S
N
Q1
(a) A light-dependent resistor (LDR) is used to sense the amount of light in a room.
Fig. 6.1 shows part of the circuit used. The LDR is not shown.
P
Q
V
Fig. 6.1
(i)
Complete Fig. 6.1 by drawing the circuit symbol for an LDR between points P and Q. [1]
(ii)
Explain how the voltmeter reading changes as the amount of light falling on the LDR
increases.
...........................................................................................................................................
...........................................................................................................................................
..................................................................................................................................... [2]
(b) Fig. 6.2 shows part of a circuit containing three resistors.
X
6.0 Ω
2.4 A 4.0 Ω
5.0 Ω
Y
Fig. 6.2
The current in the 4.0 Ω resistor is 2.4 A.
(i)
Show that the current in the 5.0 Ω resistor is 1.9 A.
(ii)
Calculate the potential difference (p.d.) between points X and Y.
[2]
p.d. = ......................................................... [3]
2
Fig. 5.1 shows a simple d.c. motor used in a toy car.
N
coil
axle
S
A
B
…………………………………………
…………………………………………
Fig. 5.1
Terminals A and B are connected to a battery and the motor rotates.
(a) On Fig. 5.1, add labels inside the boxes to identify the parts of the motor indicated.
[2]
(b) State what happens to the rotation of the coil when:
(i)
the number of turns on the coil is increased
..................................................................................................................................... [1]
(ii)
the magnetic field between the poles of the magnet is reversed.
..................................................................................................................................... [1]
3
(a) A student connects a battery, thermistor X and resistor Y in parallel, as shown in Fig. 5.1.
E
X
I
Y
Fig. 5.1
•
•
•
The electromotive force (e.m.f.) of the battery is E.
The current in X is I.
The resistance of Y is greater than the resistance of X.
Tick two boxes, one to show the correct statement about the potential difference across Y
and the other to show the correct statement about the current in Y.
The potential difference across Y:
is less than E
is equal to E
is greater than E.
The current in Y:
is less than I
is equal to I
is greater than I.
[1]
[Turn over
(b) The student connects thermistor X in series with the resistor Y and a battery of e.m.f. 6.0 V, as
shown in Fig. 5.2.
6.0 V
X
Y
Fig. 5.2
In this circuit, at room temperature, the resistance of thermistor X is 600 Ω and the current in
thermistor X is 0.0020 A.
(i)
Calculate the power produced in the thermistor.
power = ......................................................... [2]
(ii)
Calculate the resistance of Y.
resistance = ......................................................... [2]
(iii)
The thermistor is cooled.
Explain why this causes the potential difference across Y to decrease.
...........................................................................................................................................
...........................................................................................................................................
..................................................................................................................................... [2]
9
4
(a) Fig. 6.1 shows part of a toy which contains two ring-shaped, permanent magnets. A plastic
rod passes through the centre of both magnets.
top magnet
plastic rod
N
S
N
S
N
S
bottom magnet
Fig. 6.1
The top magnet can move up and down freely around the plastic rod.
The magnetic poles on the bottom magnet are shown in Fig. 6.1.
(i)
The top magnet floats in the air above the bottom magnet.
On Fig. 6.1, mark the poles on the top magnet and explain why it floats in the air above
the bottom magnet.
...........................................................................................................................................
...........................................................................................................................................
...........................................................................................................................................
..................................................................................................................................... [3]
(ii)
The top magnet is replaced with a ring made of iron.
Explain why the iron ring sticks to the bottom magnet.
...........................................................................................................................................
...........................................................................................................................................
...........................................................................................................................................
..................................................................................................................................... [2]
[Turn over
(b) A wire carrying a current passes at right angles through a piece of paper.
Fig. 6.2 shows a cross and circle where the current in the wire passes into the plane of
the paper.
piece of
paper
wire
Fig. 6.2
On Fig. 6.2, sketch three magnetic field lines to show the magnetic field pattern around
the wire.
Show the direction of the field on your sketch.
[2]