CNST 1120
Lab Exercise #13
Name: ________________________
FCS: Electrical E0.1 – T1.1
The “Electrical Drawings” for the “Farm Credit Services of America” building are to
be used to answer the following questions. You may still have to go to other drawings
in the set to fully understand (coordinate) what is being required.
In addition to the answer, provide the location reference information indicating where
the answer was found. 0.5 point each, unless specified.
1. Which drawing is to be used to determine the exact location of all ceiling mounted
devices?
2. How many, and what size of buried electrical service entrance conduits are required to
be installed between the electrical transformer and the building? How deep are these
conduits to be buried?
3. How many light fixtures are required in Conference Room #114? What is the fixture type
designation? What is the fixture manufacturer’s name?
4. How many exit signs are required?
5. How many lamps are required in each of the light fixtures in Office #108?
6. What is the “Main Breaker” size for Panel Board “A”?
8. What circuit(s) is/are the wall mounted duplex power receptacle(s) in Office #106 on?
9. How high above the floor is the wall mounted duplex receptacle for the microwave oven
in Lounge #124 to be mounted? What circuit is it on?
10. Refer to Lounge #124: (1 pt)
a. How many telephone and telephone/data outlets are to be provided?
b. How high above the floor are the devices to be mounted?
c. How many category 5e cables must be provided to the telephone/data outlet?
11. What is the mounting height for the wall-mounted battery powered emergency light
fixtures located in Open Office #110? What circuit are they on?
11. What is the name of the manufacturer of the light fixture that is to be mounted on the light
pole located on the east side of the parking lot?
12. How many driven ground rods are required to be installed as part of the “main service
entrance” ground connection?
1 of 2
13. What is the “amp” rating for the main “Electrical Distribution Panel” (MDP)?
14. What is the size of the driven ground rod that is to be installed as part of light fixture Type
“M” pole base?
15. What type of electrical outlet is to be installed in Janitors Closet #118? (Provide both the
abbreviation and what it stands for.)
16. Identify The Following Electrical Symbols Used in the FCS Drawing Set. (0.25 pt, each)
2 of 2
0
