Get Valid Huawei H35-581_V2.0-ENU Dumps For Best Preparation
Exam
:
H35-581_V2.0-ENU
Title
: HCIP-5G-RNP&RNO V2.0
https://www.passcert.com/H35-581_V2.0-ENU.html
1two8
Get Valid Huawei H35-581_V2.0-ENU Dumps For Best Preparation
1. Which of the following is not a process for PUCCH channel management?
A. UE decides on its own resources to send UCI
B. UE sends UCI based on the allocated resources
C. gNodeB allocates PUCCH resources to UE
D. Cell-level PUCCH configuration
Answer: A
2. Which of the following descriptions about 5G PRACH is correct?
A. The length of the GT protection time in PRACH is related to the PUSCH SCS
B. PUSCH SCS does not affect the calculation of cell radius
C. The duration of the CP in PRACH is related to the PRACH SCS
D. PRACH SCS and PUSCH SCS must be consistent
Answer: B
3. Which of the following is not a 5G voice solution?
A. 5Gto3GCSFB
B. VoNR
C. Dual Registration
D. EPS Fllback
Answer: A
4. Which of the following in the terminal capability report indicates that the terminal supports?
A. SupportedSRS-TxPortSwitch: t2t4
B. maxNumberSRS
C. SupportedSRS-Resource: 1t2r
D.SupportedSRS-AntennaSwitching
Answer: D
5. Which of the following descriptions about the frequency domain location of the PRACH channel is
correct?
A. Can be placed anywhere in the frequency domain
B. Must be included in the initial BWP
C. Must be configured at the bottom of the frequency band
D. Must be included in a dedicated BWP
Answer: B
6. Which of the following descriptions about EN-DC dual connection networking is incorrect?
A. In current commercial networks, UE can only establish a signaling interface with one base station on
the air interface.
B. UE can establish user plane with two base stations on the air interface
C. Only supports dual connections of 4G and 5G
D. The signaling plane is built on the 5G side
Answer: D
2two8
Get Valid Huawei H35-581_V2.0-ENU Dumps For Best Preparation
7. The 5G frequency grid defines the central frequency of the NR cell. What is 4FG1oba1 in the frequency
number calculation formula of Sub3G?
A. 60kHz
B. 5kHz
C. 15kHz
D. 30kHz
Answer: B
8. How long does it take for the UE to transition from RRC INACTIVE to RRC_IDLE if there is no service
and the serving gNodeB does not change?
A. 1500s
B. 1000s
C. 1800s
D. 1200s
Answer: B
9. 5G PUSCH supports two waveforms: CP-OFDM and DFT-S-OFDM. Which of the following
descriptions is incorrect?
A. DFT-S-OFDM advantage: can use discontinuous frequency domain resources
B. CP-OFDM advantages: can use discontinuous frequency domain resources
C. DFT-S-OFDM advantages: PAPR can be close to that of a single carrier, and higher transmission
power
D. Disadvantages of CP-OFDM: High PAPR peak-to-average ratio
Answer: A
10. Which of the following events is used by the gNodeB to perform the target cell or target frequency
decision based on coverage inter-frequency handover?
A. A2 Event
B. A5 event
C. A1 event
D. B1 event
Answer: B
11. In DRAN networking, which transmission solution is recommended for the fronthaul interface?
A. Active Wavelength Division Multiplexing
B. Passive WDM
C. Fiber Direct Drive
D. All of the above
Answer: D
12.Which of the following processes is not included in the UE initial registration process?
A. RRC connection establishment
B. NAS Authentication and Security Process
C. Session Establishment
3two8
Get Valid Huawei H35-581_V2.0-ENU Dumps For Best Preparation
D. UE Capabilities and AS Security
Answer: C
13. Which of the following scenarios regarding SU-MIMO is incorrect?
A. gNodeB 64T, UE 4R: The maximum number of PDSCH streams is 4
B. gNodeB 2R, UE 2T: The maximum number of PUSCH flows is 2
C. gNodeB 2T, UE 4R: Maximum number of PDSCH streams is 4
D. gNodeB 64R, UE 2T: Maximum number of PUSCH streams is 2
Answer: C
14.Which of the following descriptions about MU-MIMO pairing is incorrect?
A. The channel correlation is strong and more suitable for MU-MIMO pairing
B. SINR is higher and the beam isolation between UEs is greater, which is more suitable for MU-MIMO
pairing
C. MU-MIMO pairing is limited by channel conditions and product capabilities
D. Massive MIMO narrow beam environment is more suitable for MU-MIMO pairing
Answer: A
15. What does it mean if the terminal receives a TA value of 40 in the SA cell?
A. The terminal moves out of the control area
B. The terminal is farther away from the base station
C. The terminal position has not changed
D. The terminal is closer to the base station
Answer: B
16. Comparing QoS and slice SLA, which of the following descriptions is incorrect?
A. QoS is the basis of slice SA
B. Slice SLA adjusts resources to meet business needs over a longer period of time
C. The maximum number of slices supported is 254
D. Slice SL A is aimed at all-round needs such as user experience, system performance, deployment and
operation and maintenance
Answer: C
17.Which of the following information does the self-optimization function of ultra-distant neighbor
identification not refer to when optimizing neighbor attributes?
A. Drop rate
B. Number of switching
C. Distance between neighboring areas
D. Switching success rate
Answer: C
18. If the maximum transmit power of a cell is 100W, SCS=30kHz, bandwidth is 100MHz, and 64T64R
AAU is used, what is the approximate cell reference power?
A. 31.9dBm
4two8
Get Valid Huawei H35-581_V2.0-ENU Dumps For Best Preparation
B. 0 dBm
C. -33dBm
D. 34dBm
Answer: C
19. Which of the following requirements is an entry condition for the A3 event?
A. Mn+Ofn+Ocn+Hys<Ms+Ofs+Ocs-Off
B. Mn+Ofn+Ocn-Hys<Ms+Ofs+Ocs+Off
C. Mn+Ofn+Ocn+Hys>Ms+Ofs+Ocs-Off
D. Mn+Ofn+Ocn-Hys>Ms+Ofs+Ocs+Off
Answer: D
20. Which of the following events is used by the gNodeB to determine the target cell or target frequency
for service-based inter-frequency handover?
A. A4 incident
B. B1 Event
C. A5 event
D. A2 event
Answer: A
21. Low MCS is a common problem that causes low downlink rate. Which of the following descriptions
about low MCS is incorrect?
A. The higher the IBLER, the higher the MCS
B. When RSRP is high and SIN is low, the cause of interference should be analyzed
C. Control the neighboring cell SSB RSRP to be 6dB lower than the serving cell
D. When testing the peak rate, the recommended MCS is 27
Answer: A
22. In the Option 3x architecture, which protocol layer is responsible for data diversion?
A. Anchor PDCP
B. Anchor RLC
C. NR PDCP
D. NR RLC
Answer: C
23. Which information is not included in the parameter PRACH Configuration lndex?
A. Preamble format
B. Slot number
C. Wireless Frame
D. PRB Location
Answer: A
24. In a scenario where the 5G cell bandwidth is 100MHz and the subcarrier spacing SCS is 30KHz, what
is the minimum protection bandwidth?
5two8
Get Valid Huawei H35-581_V2.0-ENU Dumps For Best Preparation
A. 845KHzB
B. 925KHz
C. 825KHz
D. 860KHz
Answer: A
25.Which transmission method does Huawei base station CSI-RS for BM currently support?
A. Semi-static
B. Semi-dynamic
C. Cycle
D. Non-periodic
Answer: C
26. Which of the following protocol layers completes the resource scheduling on the base station side?
A. PDCP
B. RLC
C. MAC
D. SDAP
Answer: C
27. Among the following PDSCH DMRS configuration schemes, which one has the largest overhead?
A. Type2 leading single symbol
B. Type1 leading single symbol
C. Type2 double leading symbol
D. Type1 double leading symbol
Answer: C
28. Which parameter in the MIB message indicates the number of time domain symbols of CORESETO?
A. PDCCH - ConfigSIB1 high 4 bits
B. ssb-subcarrier Offset
C. system frame number
D. PDCCH - configSIB1 lower 4 bits
Answer: D
29. In the LNR time synchronization scenario, what is the maximum LTE power when the uplink subframe
is concurrent?
A. 23dBm
B. 20dBm
C. 26dBm
D. 17dBm
Answer: A
30. Which of the following signaling is used to release a PDU session initiated by the base station?
A. PDU Session Resource Notify
6two8
Get Valid Huawei H35-581_V2.0-ENU Dumps For Best Preparation
B. PDU Session Resource Release Response
C. PDU Session Resource Release Command
D. UE Context Release Command
Answer: A
31.Which of the following is not included in the QoS flow involved in IMS video services?
A. 5Ql=2
B. 5Ql=1
C. 5Q=5
D. 5Ql=9
Answer: D
32. When troubleshooting NR cell interference with SCS=30kHz, what is the normal interference noise
floor at the PRB level?
A. -115dBm
B. -90dBm
C. -110dBm
D. -125dBm
Answer: A
33. What link does blind switching not include compared to normal switching?
A. Target cell determination phase
B. Measurement
C. Switching stage
D. Triggering stage
Answer: B
34. Which of the following descriptions of Huawei SA cell context abnormal release scenarios is incorrect?
A. Can be triggered by gNodeB or AMF
B. Determine whether it is an abnormal release based on the reason value carried in the signaling
C. The user plane will be released
D. The control surface will not be released
Answer: D
35. Which of the following descriptions about codeword stream mapping is incorrect?
A. The number of streams is equal to the number of beams
B. Different ports of a codeword share the same DMRS signal
C. In a multi-stream scenario, each narrow beam is equivalent to one stream.
D. Layer mapping is similar to serial-to-parallel conversion
Answer: B
36. When the NR cell subcarrier spacing SCS = 30KHz, what is the maximum number of PDCCH blind
detections?
A. 36
7two8
Get Valid Huawei H35-581_V2.0-ENU Dumps For Best Preparation
B. 44
C. 22
D. 20
Answer: A
37. The logical channel is located between the MAC layer and the RLC layer. Which of the following does
not belong to the control channel?
A. DCCH
B. BCCH
C. PCCH
D. DTCH
Answer: D
38.Which piece of information will not be referenced by the automatic deletion of neighbor relations
feature?
A. Neighborhood specifications
B. Neighborhoods that have not been used for a while
C. gNodeB Neighborhood Cell Specifications
D. X2/Xn Specifications
Answer: D
39. In which of the following scenarios will Huawei base station carrier aggregation delete SCell?
A. The uplink and downlink channel quality is lower than the threshold
B. The uplink and downlink traffic volume is less than the threshold
C. SCell is unavailable due to a fault or other reasons
D. High-frequency cells report SCell A2 events
Answer: C
40. Assuming that the SSB physical layer period is configured to be 10ms, how many SSB scans are
required for the same MIB block?
A. 2 times
B. 8 times
C. 4 times
D. 6 times
Answer: B
41.Where is the simulated weighted calculation and superposition of Huawei 5H high-frequency
beamforming completed?
A. Master Control
B. Baseband
C. Radio Frequency
D. Terminal
Answer: C
8two8