전기전자 실험
Measurement of Resistance
Basic Experiment I
1
목차
•
•
•
•
•
Basic Experiment I
2
1
2
3
일반 저항기의 색상 코드 및
SMD type의 저항 코드를
사용하여 명목값을 확인할 수
있다.
디지털 멀티미터(DMM) 또는
아날로그 테스터(VOM)를
사용하여 저항 값을 측정할 수
있다.
측정된 저항 값과 명목값 간의
퍼센트 차이를 계산할 수 있다.
Basic Experiment I
3
저항 - Resistor
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses. High-power resistors that can dissipate many watts of electrical power as heat, may be used as part of motor controls, in power distribution systems, or as test loads for generators. Fixed resistors have resistances that only change slightly with temperature, time or operating voltage. Variable resistors can be used to adjust circuit elements (such as a volume control or a lamp dimmer).
★ ref. https://en.wikipedia.org/wiki/Resistor
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element.
In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active
elements, and terminate transmission lines, among other uses. High-power resistors that can dissipate many watts
of electrical power as heat, may be used as part of motor controls, in power distribution systems, or as test loads
for generators. Fixed resistors have resistances that only change slightly with temperature, time or operating voltage.
Variable resistors can be used to adjust circuit elements (such as a volume control or a lamp dimmer).
★ ref. https://en.wikipedia.org/wiki/Resistor
Basic Experiment I
4
저항 – Resistor 종류와 구조
고정 저항(fixed resistor)
Basic Experiment I
가변 저항(variable resistor)
저항 – Resistor 종류와 value 읽기
Carbon Resistor
칩 SMD Resistor
가변 variable Resistor
저항
Site
(계산기
Digi-key )
★ Carbon
★ Carbon저항 계산기 Site ( Digi-key )
Basic Experiment I
6
저항 – Ohm’s law와 소비전력
Ohm's law
The behaviour of an ideal resistor is dictated by the relationship specified by
Ohm's law:
Ohm's law states that the voltage (V) across a resistor is proportional to the
current (I), where the constant of proportionality is the resistance (R).
소비전력
At any instant, the power P (watts) consumed by a resistor of resistance R (ohms) is
calculated as:
where V (volts) is the voltage across the resistor and I (amps) is the current flowing
through it. Using Ohm's law, the two other forms can be derived.
Basic Experiment I
Resistors are rated according to their maximum power dissipation. Discrete resistors
in solid-state electronic systems are typically rated as 1/16, 1/8, or 1/4 watt.
7
저항 – Power rating
저항을 선정할 때에는 소비 전력을 계산하고 그 이상의 power
①
rating의 저항을 선정하여야 한다.
②
R
P*R = I X V
= 1[A] X 10[V]
= 10[W]
③
④
저항 R을 좌측 부품중에 선정하여야 한다면 20W의 저항④가 적절한
선택이 될 것이다.
Basic Experiment I
8
디지털 멀티미터(DMM)
브레드보드(BreadBoard)
부품
1. 저항 : 390, 2.2K, 15K, 22K, 100K, 2.2K, 4.7K, 5.6K, 10K, 1k
potentiometer(VR)
Basic Experiment I
9
Measurement of Resistance
[실험 절차]
1. 주어진 저항의 색깔을 표2에 기록하고 코드에 따른 저항값을 기록하시오.
2. 저항을 측정하고 측정값과 오차를 기록하시오.
Basic Experiment I
Measurement of Variable Resistance
[실험 절차]
1. Step3 : 주어진 가변 저항의 단자1과 단자3의 저항을 측정한다.
2.Step4 : 가변저항을 임의 위치에 놓고 단자1과 단자2와 단자2과 단자3 사이의 저항을
측정하고 두 합을 계산하요 Table3에 기록한다.
3.Step5 ~ step 6. : 동일한 가변저항으로 위 step 3을 반복하고 표3에 기록한다.
Basic Experiment I
11
Measurement of Resistance
1.What is the resistance below chip type resistors ?
Basic Experiment I
12
1. 색 코드로 표시된 값과 측정된 값 사이의 퍼센트 차이가 미터기의 오차 때문일 가능성이
있다고 의심됩니다. 이를 확인하는 방법은 무엇인가요?
2. 포텐시오미터(Potentiometer)의 축을 시계 방향(CW)으로 완전히 돌렸을 때, 단자 1-2와 2-3
사이의 예상 저항을 예측하세요.
3. 저항의 색 코드가 빨강-보라-주황-금색인 경우:
(a) 공차 범위 내에서 저항이 가질 수 있는 최대값은 얼마인가요?
(b) 공차 범위 내에서 저항이 가질 수 있는 최소값은 얼마인가요?
4. 실험 계산에서 색 코드로 표시된 값이 아닌 측정된 값을 사용해야 하는 이유를 설명하세요.
Basic Experiment I
1. 실험 목적
2. 관련 이론
3. 실험 순서
4. 실험 결과
5. 분석 및 고찰
6. 결론
Basic Experiment I
Q&A
< 3주차 수업 공지 >
1. 수업 제목 : 옴의법칙과 키르히호프의 법칙
2. 수업 내용 : 옴의법칙과 키르히호프의 법칙
3. 과제 : 2주차 보고서( 2주차 결보 + 3주차 예보 )
Basic Experiment I