Zonal & Station Identification
Systems
Model S64F Helicopter
Rev. A Sept 18, 2007
2-1
Erickson Air-Crane
S64F Technical Publications
S-64E
AIRFRAME
PRATT & WHITNEY
ENGINE
OPTIONAL
EQUIPMENT
Maintenance Manual
for Model S-64F Helicopter
Publication No. 3EAC006
Rev. IR In Work
P&W JT12A, -6A and -8 Turbojet
Engines and JFTD12A-4A and -5A
Free Turbine Engines Maintenance Manual
P/N 435107, Revised May 31, 1995
Maintenance and Operations Manual
for Fire Retardant Tank
STC No. SR00004SE
Publication No. EAC009 -Rev. 4/15/00
Illustrated Parts Catalog for
Models S-64E and S-64F Helicopters
Publication No. 3EAC008
Rev. June 15, 1999
P&W JT12A and JFTD12A Engines
Illustrated Parts Catalog
P/N 435109
Revised January 15, 1996
Maintenance Manual
for Foam Cannon
STC SR000815SE
Publication No. EAC013 - Rev. IR In Work
Service Bulletins for
Model S-64F
Series Helicopters
Pratt & Whitney
Service Bulletins
Logging Pendant
Illustrated Parts Catalog
TM 6485-1051A - Rev. July 26, 1995
Manufacturer's
Progressive
Inspection Checklist
Electrical Schematic
Manual
Rev. A Sept 18, 2007
2-2
Airframe
S-64F MAINTENANCE MANUAL, Pub. No. 3EAC006
Manual Organization
Manual Layout
A.
B.
C.
D.
E.
Rev. A Sept 18, 2007
Revision Record
List of Effective Pages
Table of Contents
Chapters
Chapter Locations
Chapter Organization
1. Chapter Table of Contents
2. Component Description
3. Servicing Instructions
4. Inspection
5. Removal
6. Disassembly
7. Assembly
8. Installation Instructions
2-3
Airframe
S-64F MAINTENANCE MANUAL, Pub. No. 3EAC006
Manual Organization
VOLUME I
1. Aircraft General
2. Airframe
3. Alighting Gear
4. Power plants
5. Rotors
6. Drive Train System
Rev. A Sept 18, 2007
VOLUME II
7. Hydraulic Systems
8. Instruments
9. Electrical Systems
10. Fuel Systems
11. Flight Controls
12. Utility Systems
13. Environmental Control
Systems
14. Hoists and Winches
15. Auxiliary Power Plant
16. Emergency Equipment
17. Optional Equipment
2-4
Airframe
S-64F MAINTENANCE MANUAL Pub. No. 3EAC006
Manual Organization (Continued)
VOLUME II (continued)
Appendix A. Special Inspections
Appendix B. Consumable Maintenance Supplies and
Material
Appendix C: Special Tools & Test Equipment
Electrical Schematic Manual
Separate from Maintenance Manual. -Aircraft Specific
Rev. A Sept 18, 2007
2-5
Airframe
S-64E AND S-64F ILLUSTRATED PARTS CATALOG
Pub. No. 3EAC008
Manual Organization
The Illustrated Parts Catalog lists repair parts, airframe tools,
test, measurement and diagnostic equipment.
A. Revision Record
B. List of Effective Pages
C. Table of Contents
D. Chapter Organization - Chapter titles are the same
as the Maintenance Manual Chapters.
E. Alphanumeric Index
Rev. A Sept 18, 2007
2-6
Airframe
S-64E AND S-64F ILLUSTRATED PARTS CATALOG
Pub. No. 3EAC008 Indention System
For proper identification of detail parts and next assemblies, listings
are in the following indention system:
1234567
ASSEMBLY
ATTACHING PARTS FOR ASSEMBLY
-*SUBASSEMBLY
ATTACHING PARTS FOR SUBASSEMBLY
-*DETAIL PARTS
ATTACHING PARTS FOR DETAIL PARTS
The next higher assembly of any detail part may be determined by
locating, in the next column to the left, excluding any attaching parts,
the first item above the detail in question.
Rev. A Sept 18, 2007
2-7
Airframe Model S-64F
SERVICE BULLETINS
Manufacturer’s Service Bulletins
A. Service Bulletin Index - List of all Service Bulletins
applicable to the S-64F Helicopter
B. Service Bulletin 64B General-1, TIME LIMITS - Retirement
Schedule - List of all Life Limited Parts
C. Service Bulletin 64B General-2, MAJOR COMPONENTS Maximum Recommended Time Between Overhauls
D. Service Bulletin Organization
1. Planning Information
2. Accomplishment Instructions
3. Material Information
Rev. A Sept 18, 2007
2-8
Airframe
MANUFACTURER’S PROGRESSIVE INSPECTION
CHECKLIST
ZONE NO. 1: Cockpit All surfaces,
material, components, and equipment
located interior and exterior of the
cockpit, electronics compartment, and
overhead crawlway (attic) extending aft
to the forward fuel cell bulkhead at
station 248 and the aft pilot's cockpit)
ZONE NO. 2: Power Plant No. 1 and
No. 2 power plants, (includes, but not
limited to, the main engines, engine
accessories, drive shafts.
ZONE NO. 3: Fuselage Sides and
Bottom All surfaces, material,
components, and equipment located
interior and exterior of the fuselage
right and left sides and bottom from
fuselage STA 210 to 772 (includes, but
not limited to, load levelers, hoist,
pendant and cable, hoist well, bottom
of main gear box and the cargo hook).
Rev. A Sept 18, 2007
2-9
Airframe
MANUFACTURER’S PROGRESSIVE INSPECTION
CHECKLIST
ZONE NO. 4: Fuselage Top All surfaces,
(Continued)
material, components and equipment located
above and including the top surface of the
fuselage from STA 210 to 772 (includes, but
not limited to, the upper portion of the main
gear box, main rotor head and blades,
hydraulic panels, auxiliary power plant and
drive shafts).
ZONE NO. 5: Pylon All surfaces, material,
components and equipment located interior
and exterior aft of STA 772 (includes, but not
limited to, horizontal stabilizer, tail rotor and
blades, tail gear box, intermediate gear box
and tail skid).
ZONE NO. 6: Main Landing Gear and Support
Installation All surfaces, material,
components and equipment located interior
and exterior of the right and left main landing
gears and support installations outboard from
fuselage center section right and left sides.
Rev. A Sept 18, 2007
2-10
Airframe
IV. MANUFACTURER’S PROGRESSIVE INSPECTION
CHECKLIST (Continued)












INTERVAL
Daily
15 Flight Hrs
30 Flight Hrs
INSPECTIONS TO BE PERFORMED
Walk around and special inspections as required.
Safety Inspection of all zones.
Phase I Inspection, Zone I - which includes Zone I Safety Inspection.
Safety Inspection of all remaining zones.
45 Flight Hrs Safety Inspection of all zones.
60 Flight Hrs Phase II Inspection, Zone II - which includes Zone II Safety
Inspection. Safety Inspection of all remaining zones.
75 Flight Hrs Safety Inspection of all zones.
90 Flight Hrs Phase III Inspection, Zone III - which includes Zone III Safety
Inspection. Safety Inspection of all remaining zones.
105 Flight Hrs Safety Inspection of all zones.
120 Flight Hrs Phase IV Inspection, Zone IV - which includes Zone IV Safety
Inspection. Safety Inspection of all remaining zones.
135 Flight Hrs Safety Inspection of all zones.
150 Flight Hrs Phase V Inspection, Zones V and VI - which includes Zones V
and VI Safety Inspection. Safety Inspection of all remaining zones.
Rev. A Sept 18, 2007
2-11
Pratt & Whitney Engine
JFTD12B ENGINE MAINTENANCE MANUAL #435107
Manual Organization
A. Revision Record - Revision Service provided by P&W for a
yearly fee.
B. List of Effective Pages
C. Table of Contents
D. Sections
Introduction
I. Tools
II. Maintenance
III. Periodic Inspection
IV. Preparation for Storage or Service
Appendix I. Consumable Materials
Appendix II. Lock Wiring
Rev. A Sept 18, 2007
2-12
Pratt & Whitney Engine
JFTD12A Engine ILLUSTRATED PARTS CATALOG #435109
Manual Organization
A. Revision Record
B. List of Effective Pages
C. Table of Contents
D. Sections
I. Introduction
II. Group Assembly Parts List
III. Numerical Index.
Rev. A Sept 18, 2007
2-13
Pratt & Whitney Engine
JFTD12A SERVICE BULLETINS
Manufacturer’s Service Bulletins
A. Service Bulletin Index
B. Service Bulletin #1508 - “Engine - Operating Time
Between Overhauls, and Frequency of Combustion
Area Inspections - Information Concerning”
C. Service Bulletin Organization
1. Planning Information
2. Accomplishment Instructions
3. Material Information
Rev. A Sept 18, 2007
2-14
Optional Equipment
OPTIONAL EQUIPMENT PUBLICATIONS
Maintenance and Operation Manual
for Fire Retardant Tank
Publication No. EAC009
Maintenance Manual
for Foam Cannon
Publication No. EAC013
Manual Organization
1. Revision Record
2. List of Effective Pages
3. Table of Contents
4. Chapter Organization
Rev. A Sept 18, 2007
Logging Pendant
Illustrated Parts Catalog
Publication No. TM 6485-1051A
Chapter 1 - System Description &
Operations
Chapter 2 - Installation
Chapter 3 - Inspection Guide Program
Chapter 4 - Removal Instructions
Chapter 5 - Field Maintenance
Procedures
Chapter 6 - Troubleshooting
Chapter 7 - Illustrated Parts Breakdown
Appendix A - Wiring Diagrams
Appendix B - Hydraulic Schematics
2-15
Erickson Air-Crane
S-64E
S64F Technical Publications
AIRFRAME
PRATT & WHITNEY
ENGINE
OPTIONAL
EQUIPMENT
Maintenance Manual
for Model S-64F Helicopter
Publication No. 3EAC006
Rev. IR In Work
P&W JT12A, -6A and -8 Turbojet
Engines and JFTD12A-4A and -5A
Free Turbine Engines Maintenance Manual
P/N 435107, Revised May 31, 1995
Maintenance and Operations Manual
for Fire Retardant Tank
STC No. SR00004SE
Publication No. EAC009 -Rev. 4/15/00
Illustrated Parts Catalog for
Models S-64E and S-64F Helicopters
Publication No. 3EAC008
Rev. June 15, 1999
P&W JT12A and JFTD12A Engines
Illustrated Parts Catalog
P/N 435109
Revised January 15, 1996
Maintenance Manual
for Foam Cannon
STC SR000815SE
Publication No. EAC013 - Rev. IR In Work
Service Bulletins for
Model S-64E
Series Helicopters
Pratt & Whitney
Service Bulletins
Logging Pendant
Illustrated Parts Catalog
TM 6485-1051A - Rev. July 26, 1995
Manufacturer's
Progressive
Inspection Checklist
Electrical Schematic
Book
Rev. A Sept 18, 2007
2-16