H13-629_V3.0 HCIE-Storage (Written) V3.0 https://www.certspots.com/exam/h13-629_v3-0/ Huawei H13-629_V3.0 Real Dumps 1. Which of the following does not cause value-added service faults? A. The replication links between storage devices are inconsistent. B. LUNs are disconnected unexpectedly. C. Logging in to a remote storage device through a serial port fails. D. A storage pool of a remote storage device goes offline. Answer: C Huawei H13-629_V3.0 Real Dumps 2. A maintenance engineer discovers that the fault indicator of a storage device is flashing. The management UI tells the engineer that a RAID group degradation alarm is generated becaus disk fault. The disk is then replaced and the fault is rectified. During this process, which of the following basic troubleshooting methods is used by the maintenance engineer? A Logical reasoning B. Phenomenon analysis C. Replacement D. Alarm analysis Answer: D Huawei H13-629_V3.0 Real Dumps 3. Customer M plans to use eReplication to build a disaster recovery (DR) solution. Which of the following statements is incorrect about the configuration of eReplication DR service? A. A remote server must be created. B. Protection groups are created based on different application types. C. A recovery plan needs to be created for data and service recovery. D. A license for eReplication is required for building the DR system. Answer: A Huawei H13-629_V3.0 Real Dumps 4. A company plans to deploy a disaster recovery (DR) system and requires that services run without interruption and service data be not lost when a data center-level fault occurs. The company plans to use a two-city three-DC geo-redundant architecture. Which of the following solutions meets the requirements? A. Local HA architecture based on an active-passive mode. B. Geo-redundant architecture based on a two-DC active-passive mode. C. Geo-redundant architecture based on a two-DC mutual backup mode. D. Geo-redundant architecture based on a two-DC active-active mode. Answer: D Huawei H13-629_V3.0 Real Dumps 5. A company purchases a Huawei hybrid flash storage system. Hosts are connected to the storage system through Fibre Channel switches. Which of the following is the optimal configuration during Fibre Channel switch configuration planning? A. Each zone contains only one host port and one storage port. B. Each host requires only one optical fiber port to connect to a switch. C. All ports of each Fibre Channel switch are in the same zone. D. High-end Fibre Channel switches are always used to ensure network performance. Answer: A Huawei H13-629_V3.0 Real Dumps 6. Huawei all-flash storage devices must be planned and designed before deployment. Which of the following does not need to be planned during storage networking? A. Management network B. Service network C. IP address D. Heartbeat network Answer: D Huawei H13-629_V3.0 Real Dumps 7. A company purchases two Huawei all-flash storage devices to deploy database services. The storage systems are respectively deployed in data centers A and B in city M with HyperMetro disaster recovery. Which of the following faults do not cause service interruption? B. Citywide power outage. C. Network fault of data center A due to engineering construction. D. Network fault between data centers A and B. Answer: ACD Huawei H13-629_V3.0 Real Dumps 8. Which of the following are supported by the inspection function of Huawei OceanStor SmartKit? A. Providing check criteria and repair suggestions. B. Sending inspection reports by email. C. Checking service status before an upgrade. D. Scheduled inspection. Answer: ABC Huawei H13-629_V3.0 Real Dumps 9. Which of the following are precautions for FRU replacement? A. Ensure that a new part is in good condition and is free from oxidation, chemical corrosion, missing components, or damage caused by transportation. B. Use special ESD bags to carry or transport parts. Properly manage, record, and repair parts in routine maintenance. C. Determine and label the cabinet or controller enclosure where a part to be replaced resides to prevent misoperation. D. Remove a faulty part with even force. Answer: ABC Huawei H13-629_V3.0 Real Dumps 10. DME supports proactive O&M powered by the Al engine and policy engine. Which of the following functions can be implemented on the DME platform? A. Performance check and prediction B. Availability check and prediction C. Capacity check and prediction D. Configuration check Answer: ABCD