Standard Downtilt kit
for Panel Antennas
(Wind load Category “L” and “M”)
Downtilt kit
Type No.
Preferred range of use
Weight
Material
Screws
Nuts / washers
737978
– Panel antennas with attached mounting plates
– Downtilt kit without scale for universal use
2.3 kg
Hot-dip galvanized steel
Hot-dip galvanized steel / stainless steel
Stainless steel
20 Nm / M8
20 Nm / M8
64
70
Ø 8.5
50 Nm / M12
336
Before the adjustment, all joint
screws must be loosened.
After the adjustment has been
completed, all loosened screws
must be tightened.
Mounting accessories included.
936.3323/c
Subject to alteration.
Ø 8.5
50
64
115
20 Nm / M8
Instructions to adjust the required downtilt angle are given in the datasheet or on the rearside of the antenna.
Mounting this downtilt kit enlarges the spacing between mast and antenna by 84 mm.
Use the downtilt kit together with the clamps as described in the antenna datasheet.
All specifications are subject to change without notice.
The latest specifications are available at www.kathreinusa.com
Kathrein USA Greenway Plaza II, 2400 Lakeside Blvd., Suite 650, Richardson TX 75082
Phone: 214.238.8800 Fax: 214.238.8801 Email: info@kathrein.com
737978 Page 1 of 2
Standard Downtilt kit
for Panel Antennas
(Wind load Category “L” and “M”)
A
Distance “A” between the jointbolts of
the downtilt kit in mm (max. 395 mm).
You will find the values for “A” on the
sticker on the backside of the antenna.
936.3323/c
Subject to alteration.
For example:
Page 2 of 2 737978
All specifications are subject to change without notice.
The latest specifications are available at www.kathreinusa.com
Kathrein USA Greenway Plaza II, 2400 Lakeside Blvd., Suite 650, Richardson TX 75082
Phone: 214.238.8800 Fax: 214.238.8801 Email: info@kathrein.com