How to Apply Polyurea Coatings Euroblast Middle East LLC People love polyurea coatings because they last a long time, are flexible, and dry quickly. This makes them perfect for many uses, from waterproofing projects to factory floors. For a good finish, applying polyurea coats needs to be done carefully and according to a set of steps. This is a full, step-by-step guide on how to put on polyurea coats. Step 1: Safety First • Gear: Wear protective clothing, gloves, safety goggles, and a respirator. Step 2: Surface Preparation • Cleaning: Remove debris, degrease, and pressure wash if needed. • Repair: Fill cracks and smooth the surface. Step 3: Priming the Surface • Primer: Choose a compatible primer and apply it evenly with a roller or brush. • Drying: Allow the primer to dry completely. Step 4: Mixing the Polyurea Components • Equipment: Use a dual-component spray machine. • Mixing: Follow the manufacturer’s 1:1 mixing ratio. Step 5: Applying the Polyurea Coating • Setup: Calibrate the spray machine and use heated hoses if necessary. • Spraying: Apply with a consistent, overlapping pattern. Apply multiple coats if needed, allowing each to cure. Step 6: Curing • Initial Cure: Takes a few minutes to hours. • Full Cure: Wait 24-48 hours before heavy use. Step 7: Inspection and Finishing Touches • Inspect: Check for uniformity and make touch-ups if needed. • Clean Equipment: Immediately clean the spray machine. Doing the right things to prepare the surface, mix the polyurea, and apply it are the keys to making it last. To get a good finish, do these steps and always follow the manufacturer's instructions. Any questions? You can find me at: ______________________________________________________ Euroblast Middle East LLC Email: info@euroblastme.com | Contact number: +971 42824400 Website: https://www.euroblastme.com Address: P.O Box 31230, Dubai, United Arab Emirates