Subway Performance Ankara Yenimahalle-Ivedik • Alpha Access Point Details (Yenimahalle – Ivedik) – pre post • Alpha Idle Mode Coverage performance – Best RSSI – pre post • Beta Access Point Details (Yenimahalle – Ivedik) – pre post • Alpha Idle Mode Coverage performance – Best RSSI – pre post • Alpha+Beta overall coverage details – pre post • Summary KARERCO @2021 Jan – 2022 1 Alpha Access Point Details (Yenimahalle – Ivedik) – pre post • Alpha 2.4 Access Points are detailed below, these are APAM107001, APAM107002, APAM107003. • MAX RSSI (dbm) idle mode performances are compared at pre post test and it seems coverage AP max RSSI performance is better at post test. • 2412, 2437 and 2462 channels are used on Alpha 2.4 Ghz layers. 2 Alpha Access Point Idle Mode Best RSSI Performance (Yenimahalle – Ivedik) • Alpha 2.4 GHz layer RSSI performance per MAC ID is as shared below, 3 access points these are APAM107001, APAM107002, APAM107003. 3 Beta Access Point Details (Yenimahalle – Ivedik) • Beta 5 GHz Access Points are detailed below, these are APBM106001 , APBM106002 , APBM106003, APBM106004, APBM106005, APBM106006 , APBM106007. • MAX RSSI (dbm) idle mode performances are compared at pre post test. APBM106002 and APBM106004 performance were not good at post test. • 5180 freq channel was in used at Beta 5 Ghz layers. 4 Beta Access Point Idle Mode Best RSSI Performance (Yenimahalle – Ivedik) • Beta 5 GHz layer best RSSI is calculated with considering 14 MAC ID, these are APBM106001 , APBM106002 , APBM106003, APBM106004, APBM106005, APBM106006 , APBM106007. 5 Alpha + Beta Access Point Idle Mode Best RSSI Performance (Yenimahalle – Ivedik) • Soft Reset was done on access points between pre and post test. • Worse samples are reduced at pre-cost comparison as it seems on plots. 3 bad coverage patches were identified at pre test. Improved at post test most probably after soft reset. Improved but still there are samples with less than -80 dbm RSSI, Completely recovered at post test. 6 Summary • Soft reset on AP help us to have much stable abd better coverage with removing sleep Access point of Alpha and beta both. So it is recommended to schedule soft reset on all access points periodically. ( every 2-3 weeks ) • There is a signal loss and weak coverage for alpha and beta both around bad patch that should be investigated. It is recommended to have physical audit, antenna output power check. In worse case 200 m barrier must be built at related part. Overall Remaining Test and Action List • Ping and HTTP Test performance in train with Ethernet link connection for Alpha and Beta both layers, • Jammer impact should be checked at specific days that may cause bad quality for Alpha and Beta channels. 7 Always ready for support ! KARERCO @2021 8